Detroit Diesel

DESCRIPTION:Coolant level circuit signal above normal range. MONITORED PARAMETER:Coolant level TYPICAL ENABLING CONDITIONS:Always on MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:Two seconds DASH LAMPS:CEL ENGINE REACTION:None VERIFICATION:Cycle key NOTE: If any other active fault codes, fix those first. PROBABLE CAUSES:1. Low coolant.2. Coolant level sensor connector/harness.3. Coolant level sensor.4. Cooling system leaks.5. Radiator cap failure. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 111 FMI 1 (CPC) Coolant Level Very Low Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 14 (MCM) Coolant Temperature/Engine Oil Temperature Plausibility Fault Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 9...

DESCRIPTION:This fault sets when the common powertrain controller (CPC) detects that there is a short to ground on the coolant level circuit or the engine coolant level is low. MONITORED PARAMETER:Coolant level TYPICAL ENABLING CONDITIONS:Always on MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:Two seconds DASH LAMPS:CEL ENGINE REACTION:None VERIFICATION:Cycle key NOTE: If any other active fault codes, fix those first. PROBABLE CAUSES:1. Low coolant.2. Coolant level sensor connector/harness.3. Coolant level sensor.4. Cooling system leaks.5. Radiator cap failure. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 111 FMI 3 (CPC) Coolant Level Circuit Failed High Detroit DD13 EPA10 (2010-13)...

NOTE: Please see the step by step troubleshooting procedures for this specific code. PROBABLE CAUSES:1. Turbocharger compressor inlet temperature sensor.2. Turbocharger compressor inlet temperature sensor connector/harness. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1077 FMI 31 (MCM) Fuel Rail Pressure Deviation is Greater than 200 Bar for Eight Seconds Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1077 FMI 15 (MCM) Internal or External Leakage of the High Pressure Fuel System Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1077 FMI 14 (MCM) Leakage in High Pressure Fuel System Too High (Leak-Down Test) Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1077 FMI...

DESCRIPTION:This fault code sets when the Motor Control Module (MCM) stops receiving messages from the Aftertreatment Control Module (ACM). MONITORED PARAMETER:ACM controller area network (CAN) communication. TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:Two seconds DASH LAMPS:1. MIL is solid.2. CEL and AWL Flash. ENGINE REACTION:30 seconds shutdown. VERIFICATION:1. Turn the ignition off.2. Disconnector the USB link from the 9 – pin connector.3. Wait five minutes.4. Reconnect the USB link and diagnostic service tool.5. Turn the ignition on and recheck for the fault code. NOTE: If there are any battery Volta codes, fix those first. If the...

NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If any other codes are present, repair them first. Otherwise, check the following for restrictions/failures:1. Plugged inlet air filters.2. Charge air cooler leaks.3. Intake manifold leaks.4. Exhaust system leaks. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 111 FMI 19 (MCM) Coolant Level Low Detroit DD13 EPA10 (2010-13) Fault Code: SPN 111 FMI 4 (CPC) Coolant Level Circuit Failed Low Detroit DD13 EPA10 (2010-13) Fault Code: SPN 111 FMI 3 (CPC) Coolant Level Circuit Failed High Detroit DD13 EPA10 (2010-13) Fault Code: SPN 111 FMI 1 (CPC)...