Tu carrito
😊 Product added to cart successfully
Product removed to cart successfully
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 51 FMI 18 (MCM) Intake Throttle Position Rationality Error
DESCRIPTION:
This fault sets when intake throttle position does not match requested range.
MONITORED PARAMETER:
Intake throttle valve (ITV).
TYPICAL ENABLING CONDITIONS:
Engine rpm = idle or higher.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
Five seconds
DASH LAMPS:
MIL
ENGINE REACTION:
No derate
VERIFICATION:
Engine rpm = idle or higher.
POSSIBLE CAUSES:
1. Damaged ITV butterfly flap.
2. Faulty ITV motor.
3. Faulty ITV sensor.
PROBABLE CAUSES:
1. Air throttle valve harness
2. ITV harness connector
3. Intake throttle valve failure
4. Cold temperatures may falsly cause this code to appear
5. Intake throttle valve sensor
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 51 FMI 10 (MCM) Intake Throttle Position Abnormal Rate of Change
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 51 FMI 4 (MCM) Intake Throttle Valve Circuit Failed Low
Detroit DD16 GHG14 (2014-16) Fault Code: SPN 51 FMI 3 (MCM) Intake Throttle Valve Circuit Failed High
Cummins ISC CM2150 (2007-09) Fault Code: 111 PID: SID 254 SPN: 629 FMI: 12 Electronic Control Module Critical Internal Failure – Bad Intelligent Device or Component. Error internal to the electronic control module (ECM) related to memory hardware failures or internal ECM voltage supply circuits.
Cummins ISC CM2150 (2007-09) Fault Code: 3616 PID: SPN: 2633 FMI: VGT Actuator Position – Special Instructions.
Cummins ISC CM2150 (2007-09) Fault Code: 2973 PID: 102 SPN: 102 FMI: 2 Intake Manifold 1 Pressure – Data Erratic, Intermittent, or Incorrect. The ECM has detected an intake manifold pressure signal that is too high or low for present engine operating conditions.