DESCRIPTION:This fault code sets when the Aftertreatment Control Module (ACM) detects a momentary abnormal Selective Catalyst Reduction (SCR) inlet temperature reading.

MONITORED PARAMETER:Selective Catalyst Reduction Inlet Temperature sensor.

TYPICAL ENABLING CONDITIONS:Non-Regen Mode

MONITOR SEQUENCE:None

EXECUTION FREQUENCY:Continuous when enabling conditions met.

TYPICAL DURATION:Two seconds

DASH LAMPS:1. MIL2. CEL

ENGINE REACTION:None

VERIFICATION:SCR efficiency test.

NOTE: This fault indicates that the ACM has detected a sudden temperature switch on the SCR outlet temperature sensor. Most likely cause is wiring failure.

NOTE: If codes 4360-3 or 4360-4 are active, fix those first.

PROBABLE CAUSES:1. Check all SCR sensor wiring for looseness, breaks, rubs, etc…2. SCR outlet temperature sensor failure.