CAT

The ECM detects the following conditions:

•The idle shutdown timer has expired and the engine has shut down.

Probable Causes:

1) It code 84-08 is active, Idle Shutdown Timer will not activate
2) Reprogram parameter in ECM
3) Brake pedal switch/harness
4) Clutch pedal switch/harness
5) Vehicle speed sensor/harness
6) PTO switch sensor/harness

The ECM detects the following conditions:

•The timer for the PTO has expired and the engine has shut down.

Probable Causes:

1) ECM Connection/Harness
2) PTO timer programmed incorrectly
3) PTO timer operated correctly and shut down as it is programmed to do
4) Check engine light or PTO switch on lamp failure
5) Vehicle speed circuit/sensor
6) PTO switch circuit/sensor

This condition indicates that the battery circuit to the Engine Control Module (ECM) has a battery condition that is intermittent while the engine is running. If battery voltage disappears without returning, the ECM will not log this diagnostic code and the engine will shut down.

The ECM detects the following conditions:

•The ignition key switch is in the ON position.
•The engine is running.
•The engine is not cranking.
•The ECM has been powered for at least three seconds.

The ECM will detect one of the following conditions:

•The battery voltage drops below 6 VDC for at least 0.50 seconds.
•Three voltage readings in the past seven seconds were below 6 VDC.

Probable Causes:

1) ECM Connection/harness
2) Battery voltage at ECM
3) Truck battery or battery cable issue
4) Aftermarket engine protection switch
5) ECM Failure

No codes, there is nothing to do.

This condition indicates that the “Transmission Style” parameter is programmed to the Eaton Top 2 and any one of the following parameters are not programmed:

•”Auxiliary Output 2″ (Multi-Function Output #2) is not programmed to “Shift Solenoid”.
•”Auxiliary Output 3″ (Multi-Function Output #3) is not programmed to “Lockout Solenoid”.
•”Gear Ratios” not programmed

Probable Causes:

Program the “Transmission Style” parameter that is Eaton Top 2 to the correct setting. If an Eaton Top 2 Transmission is not used, program the correct “Transmission Style” parameter to the correct setting.

Conditions Which Generate This Code:

This condition indicates a customer specified parameter or a system configuration parameter that requires programming has not been programmed.

Probable Causes:

1) New ECM on vehicle, needs to be programmed
2) Current ECM programmed incorrectly
3) ECM Connection/harness

The Engine Control Module (ECM) detects the following conditions:

•The ECM is unsuccessful in receiving a message from a J1939 source.
•The ECM is not receiving a valid message from a J1939 source.

Probable Causes:

1) ECM Connection/Harness
2) An ECM on the vehicle has failed or is sending improper data (Can be for anything – Cab, ABS, etc…)

The Engine Control Module (ECM) detects the following condition:

•The parameter “Powertrain Data Link” must be programmed to J1939.
•The ECM is unsuccessful in receiving a specific message from a device or
•The device is broadcasting a fault code or
•The device is broadcasting a code that is not supported.

Probable Causes:

1) ECM Connection/Harness
2) An ECM on the vehicle has failed or is sending improper data (Can be for anything – Cab, ABS, etc…)
3)

This condition indicates that the SAE J1922 data link is not communicating correctly.

Probable Causes:

1) ECM Connection/Harness
2) Another device on the J1939 is causing problems (ABS, VORAD, Cab controller, etc…)
3) Wiring from data link connector to ECM