Je winkelwagen
😊 Product added to cart successfully
Product removed to cart successfully
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4193 FMI 10 (MCM) Coolant Temperature Sensors Not Plausible
DESCRIPTION:Coolant temperature sensor not plausible.
MONITORED PARAMETER:Coolant inlet temperature sensor.
TYPICAL ENABLING CONDITIONS:1. Engine speed 500- 2500 rpm.2. Coolant temperature is greater than 11 vDC.3. Run engine greater than 60s.
MONITOR SEQUENCE:None
EXECUTION FREQUENCY:Once per drive cycle.
TYPICAL DURATION:30
DASH LAMPS:MIL
VERIFICATION:1. Start Engine.2. Warm up such that coolant temperature is greater than 11 vDC and engine has been running for at least 1 minute.3. Bring engine to idle speed.4. Being certain that it is greater than 500 rpm.
NOTE: If there are any cooling system faults or conditions, repair those first.
PROBABLE CAUSES:1. Inlet coolant temperature sensor.2. Inlet coolant temperature sensor connector/harness.
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4193 FMI 4 (MCM) Engine Coolant Inlet Temperature Circuit Failed Low
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4193 FMI 3 (MCM) Engine Coolant Inlet Temperature Circuit Failed High
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4193 FMI 2 (MCM) Coolant Inlet Temperature Not Plausible
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4100 FMI 13 (MCM, ACM) Motor Control Module or the Aftertreatment Control Module Software Not Compatible
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4077 FMI 14 (MCM) Hydrocarbon Doser Fuel Line Pressure Failed Self – Test
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4077 FMI 4 (MCM) Doser Fuel Line Pressure Sensor Circuit Failed Low