Cumminz

Taal

26 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 449 (ISC/ISL) PID: 94 SPN: 157

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

26 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 451 PID: 157 SPN: 157 FMI: 3 Injector Metering Rail Number 1 Pressure Sensor Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage detected at rail fuel pressure sensor circuit.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable...

Meer lezen

26 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 452 PID: 157 SPN: 157 FMI: 4 Injector Metering Rail Number 1 Pressure Sensor Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the rail fuel pressure sensor circuit.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable...

Meer lezen

26 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 471 PID: 98 SPN: 98 FMI: 1 Engine Oil Level – Data Valid But Below Normal Operational Range – Least Severe Level. Low oil level has been detected by the oil level sensor.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

26 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 488 PID: 105 SPN: 105

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

26 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 499 PID: 98 SPN: 98 FMI: 4 Engine Oil Level Sensor Circuit – Voltage Below Normal or Shorted to Low Source. The engine oil level sensor has detected an internal failure.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

Taal

Land/regio

Cumminz