Cumminz – Page 698 – ⛽ Diezel365

Taal

Land/regio

Telegram : @Diezel365

Cumminz

09 juni, 2025

0 reacties

Cummins ISC CM2150 (2007-09) Fault Code: 2639 PID: SID 324 SPN: 3251 FMI: 0 Aftertreatment Diesel Particulate Filter Differential Pressure – Data Valid But Above Normal Operating Range – Least Severe Level.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on Quickserve™ Online for applicable...

Meer lezen

09 juni, 2025

0 reacties

Cummins ISC CM2150 (2007-09) Fault Code: 2646 PID: 110 SPN: 110 FMI: 31 Engine Coolant Temperature – Condition Exists. The EGR valve was closed to reduce engine coolant temperature.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

09 juni, 2025

0 reacties

Cummins ISC CM2150 (2007-09) Fault Code: 2659 PID: 110 SPN: 110 FMI: 31 Engine Coolant Temperature – Condition Exists. The EGR valve was closed to reduce engine coolant temperature.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

09 juni, 2025

0 reacties

Cummins ISC CM2150 (2007-09) Fault Code: 271 PID: SID 126 SPN: 1347 FMI: 4 Fuel Pump Pressurizing Assembly 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the fuel pump actuator circuit.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

09 juni, 2025

0 reacties

Cummins ISC CM2150 (2007-09) Fault Code: 272 PID: SID 126 SPN: 1347 FMI: 3 Fuel Pump Pressurizing Assembly 1 Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage or open circuit detected at the fuel pump actuator circuit.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

09 juni, 2025

0 reacties

Cummins ISC CM2150 (2007-09) Fault Code: 2728 PID: SPN: 3556 FMI: 16 Aftertreatment Fuel Injector 1 – Data Valid but Above Normal Operational Range – Moderately Severe Level.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen