Tu carrito
😊 Product added to cart successfully
Product removed to cart successfully
Volvo All Engines (2010 Emissions) Fault Code: SPN 188 FMI 1 PID: Engine Speed at Idle, Point 1
The Engine Control Module (ECM) monitors the crankshaft angular acceleration using the flywheel sensor. The ECM monitors the camshaft position sensor to determine the engine?s position. The ECM calculates the average value of crankshaft angular acceleration for all six cylinders and compares the value to each individual cylinder?s angular acceleration. If a cylinder?s acceleration value is outside a specified range the ECM interprets this as a misfiring cylinder. The crankshaft average angular acceleration value is used by the ECM to determine cylinder balancing and idle speed.
Conditions for diagnostic trouble code (DTC):
1) Engine Speed at idle, Below normal
Observable symptoms
1) Idle Below normal
Probable cause
1) Power Take Off (PTO) installed without updating parameters and/or software
2) Parameter code, unit injector
3) Fuel
4) Injector
5) Low compression
Volvo All Engines (2010 Emissions) Fault Code: SPN 188 FMI 0 PID: Engine Speed at Idle, Point 1
Volvo All Engines (2010 Emissions) Fault Code: SPN 177 FMI 16 PID: Transmission Oil Temperature – Moderately Severe Level
Volvo All Engines (2010 Emissions) Fault Code: SPN 177 FMI 0 PID: Transmission Oil Temperature
Volvo All Engines (2010 Emissions) Fault Code: SPN 1761 FMI 5 PID: PPID 278 Aftertreatment Diesel Exhaust Fluid (DEF)
Volvo All Engines (2010 Emissions) Fault Code: SPN 1761 FMI 4 PID: PPID 278 Aftertreatment Diesel Exhaust Fluid (DEF)
Volvo All Engines (2010 Emissions) Fault Code: SPN 1761 FMI 3 PID: PPID 278 Aftertreatment Diesel Exhaust Fluid (DEF)