Ir directamente al contenido

Telegram : @Diezel365

Volvo All Engines (2010 Emissions) Fault Code: SPN 1675 FMI 0 PID: SID 39 Engine Starter Mode

The (VECU) Vehicle Electronic Control Unit supplies and monitors the cranking signal to the starter motor relay. Several types of starter cranking protection are provided so the starter cannot be engaged in unwanted conditions. The starter cranking protection will also limit the maximum cranking time to 18 seconds without cycling the key.

Conditions for diagnostic trouble code (DTC):
1) The starter motor has been activated for too long time
2) Too many tries to start

Observable symptoms
1) Not possible to activate the starter motor during a certain time
2) Text message on the display, Wait to start, and count down

Probable cause
1) Engine is difficult to start
2) Cold ambient temperature
3) Low battery voltage

Detailed information
1) If the diagnostic trouble code (DTC) is set intermittently the starter motor protection is functioning and further fault tracing is not necessary
2) If the diagnostic trouble code (DTC) is set often or at every attempt to start a fault can be suspected. Continue according to symptom fault tracing Difficult starting

Volvo All Engines (2010 Emissions) Fault Code: SPN 1659 FMI 7 PID: PSID 109 Engine Coolant System thermostat
Volvo All Engines (2010 Emissions) Fault Code: SPN 1659 FMI 12 PID: PSID 109 Engine Coolant System thermostat
Volvo All Engines (2010 Emissions) Fault Code: SPN 158 FMI 3 PID: PSID 124 Keyswitch Battery Potential
Volvo All Engines (2010 Emissions) Fault Code: SPN 158 FMI 18 PID: PSID 124 Keyswitch Battery Potential – Moderately Severe Level
Volvo All Engines (2010 Emissions) Fault Code: SPN 158 FMI 16 PID: PSID 124 Keyswitch Battery Potential – Moderately Severe Level
Volvo All Engines (2010 Emissions) Fault Code: SPN 153 FMI 7 PID: PSID 23 Engine High Resolution Crankcase Pressure