Paccar

PACCAR MX (2004 Emissions) Fault Code: U1126 CAN – Message (TSC1_SE) Time-Out from Body Builder Module SET CONDITIONS:This DTC is set when the repetition rate of the received CAN message is lower than expected or when the message is not received at all. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on or when the engine is running. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come back?–...

PACCAR MX (2004 Emissions) Fault Code: U112A CAN – Message (ACM) Time-Out from Aftertreatment System SET CONDITIONS:This DTC is set when the repetition rate of the received CAN message is lower than expected or when the message is not received at all. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on or when the engine is running. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come back?– No,...

PACCAR MX (2004 Emissions) Fault Code: U112C CAN Communication – Message (AT1FC1) Out of Range, Fuel Rate from Aftertreatment System SET CONDITIONS:This DTC is set when a CAN message is received correctly, but the content (signal value or status) is out of the expected range. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on or when the engine is running. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC...

PACCAR MX (2004 Emissions) Fault Code: U112D CAN – Message (AT1FC1) Time-Out from Aftertreatment System SET CONDITIONS:This DTC is set when the repetition rate of the received CAN message is lower than expected or when the message is not received at all. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on or when the engine is running. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come back?– No,...

PACCAR MX (2004 Emissions) Fault Code: U112F CAN Communication – Message (AT1HI) Out of Range, Total Fuel Used from Aftertreatment System SET CONDITIONS:This DTC is set when a CAN message is received correctly, but the content (signal value or status) is out of the expected range. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on or when the engine is running. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the...