Paccar– Página 218– ⛽ Diezel365


Paccar

PACCAR MX (2004 Emissions) Fault Code: P1688 Starter Motor – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (B16)

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P1688 Starter Motor – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (B16) SET CONDITIONS:This DTC is set when the ECU detects a lower voltage than expected on the signal or control circuit of the ECU. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come back?– No, repair successful–...

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P1693 Cold Starting Aid – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C72) or Pin (C49)

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P1693 Cold Starting Aid – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C72) or Pin (C49) SET CONDITIONS:This DTC is set when the ECU detects a higher voltage than expected on the signal or control circuit of the ECU. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come...

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P1694 Cold Starting Aid – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (C72) or Pin (C49)

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P1694 Cold Starting Aid – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (C72) or Pin (C49) SET CONDITIONS:This DTC is set when the ECU detects a lower voltage than expected on the signal or control circuit of the ECU. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come...

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P1698 PCI ECU 5V Sensor Supply – Voltage Too Low or Short Circuit to Ground

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P1698 PCI ECU 5V Sensor Supply – Voltage Too Low or Short Circuit to Ground SET CONDITIONS:The PCI ECU (D420) detects that the internal ‘5V power supply 4’ voltage is too low. DIAGNOSTIC CONDITION:This diagnostic runs continuously when the ignition is on. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:This DTC changes to inactive when the fault is no longer detected. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come back?– No, repair successful– Yes, repair unsuccessful POSSIBLE CAUSES:Defective PCI ECU (D420)...

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P1699 PCI ECU 5V Sensor Supply – Voltage Too High or Short Circuit to Supply

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P1699 PCI ECU 5V Sensor Supply – Voltage Too High or Short Circuit to Supply SET CONDITIONS:The PCI ECU (D420) detects that the internal ‘5V power supply 4’ voltage is too high. DIAGNOSTIC CONDITION:This diagnostic runs continuously when the ignition is on. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:This DTC changes to inactive when the fault is no longer detected. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come back?– No, repair successful– Yes, repair unsuccessful POSSIBLE CAUSES:Defective PCI ECU (D420)...

Leer más →