Paccar– Página 169– ⛽ Diezel365


Paccar

PACCAR MX (2004 Emissions) Fault Code: P0522 Engine Oil Pressure – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (C84)

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P0522 Engine Oil Pressure – Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (C84) SET CONDITIONS:This DTC is set when the ECU detects a lower voltage than expected on the signal or control circuit of the ECU. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on. RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. POSSIBLE CAUSES:1. The sensor or actuator signal wiring is interrupted.2. The sensor or actuator signal wiring has a short circuit to ground.3. A malfunction in the power supply of the...

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P0523 Engine Oil Pressure – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C84)

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P0523 Engine Oil Pressure – Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C84) SET CONDITIONS:This DTC is set when the ECU detects a higher voltage than expected on the signal or control circuit of the ECU. DIAGNOSTIC CONDITION:The diagnostic runs continuously when the ignition is keyed on. RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. POSSIBLE CAUSES:1. The sensor or actuator signal wiring has a short circuit to supply.2. A malfunction of the sensor or actuator

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P0524 Engine Oil Pressure – Data Valid but Too Low, Most Severe

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P0524 Engine Oil Pressure – Data Valid but Too Low, Most Severe SET CONDITIONS:The PCI ECU (D420) detects that the oil pressure is too low. DIAGNOSTIC CONDITION:This diagnostic runs when the engine is running for more than 8 s. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:1. This DTC changes to INACTIVE after the diagnosis runs and passes.2. This DTC cannot be cleared from the ECU memory. REPAIR VERIFICATION:1. Contact your engine field service representative for authorization to clear the warranty DTC.2. Clear all DTCs.3. Test drive or operate the vehicle to meet the diagnostic conditions...

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P0527 Fan Speed – Data Valid but Too High

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P0527 Fan Speed – Data Valid but Too High SET CONDITIONS:The PCI ECU (D420) detects that the fan speed is higher than the engine speed. DIAGNOSTIC CONDITION:The diagnostic runs when the engine speed is above 1200 rpm. CORRESPONDING OBD READINESS MONITOR:None RESET CONDITION:The DTC changes to inactive after the diagnostic runs and passes. REPAIR VERIFICATION:1. Clear all DTCs.2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.3. Did the DTC come back?– No, repair successful– Yes, repair unsuccessful POSSIBLE CAUSES:1. The sensor or actuator signal wiring has a short...

Leer más →


PACCAR MX (2004 Emissions) Fault Code: P0528 Fan Speed – Data Valid but Too Low

Publicado por Diezel Solutions en

PACCAR MX (2004 Emissions) Fault Code: P0528 Fan Speed – Data Valid but Too Low SET CONDITIONS:The PCI ECU (D420) detects that the fan speed is below 50 rpm. DIAGNOSTIC CONDITION:The diagnostic runs when the engine speed is above 1200 rpm. RESET CONDITION:This DTC changes to INACTIVE after the diagnosis runs and passes. POSSIBLE CAUSES:1. The fan does not rotate freely (for example, fan blade hits the wind tunnel).2. The sensor or actuator signal wiring is interrupted.3. The sensor or actuator signal wiring has a short circuit to ground.4. A malfunction in the power supply of the sensor5. A malfunction...

Leer más →