PACCAR PX-8 CM2150 (2007-09) Fault Code: 2637 PID: SPN: 3050 FMI: 11 Catalyst Face Plugged – Root Cause Not Known. The front face of the aftertreatment diesel oxidation catalyst has been detected to be plugged with soot.

Verify the ECM calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable fixes to the calibration stored in the ECM. If necessary, calibrate the ECM.

This fault code is set when the inlet face of the DOC is detected to be plugged with soot. The engine is taking corrective action to clean the DOC. No troubleshooting is required if this is the only fault. This is an information fault only.

Possible repairs:

1)If necessary, calibrate the ECM.

PACCAR PX-8 CM2150 (2007-09) Fault Code: 2636 PID: SID 027 SPN: 641 FMI: 9 VGT Actuator Driver Circuit – Abnormal Update Rate. No communications on the J1939 data link between the engine ECM and the smart VGT controller.

PACCAR PX-8 CM2150 (2007-09) Fault Code: 2635 PID: SID 027 SPN: 641 FMI: 11 VGT Actuator Driver Circuit – Condition Exists. A calibration mismatch between the VGT actuator and the ECM has been detected.

PACCAR PX-8 CM2150 (2007-09) Fault Code: 2634 PID: SID 027 SPN: 641 FMI: 12 VGT Actuator Controller – Bad Intelligent Device or Component. An internal error has been detected by the smart VGT controller.

PACCAR PX-8 CM2150 (2007-09) Fault Code: 2558 PID: SID 057 SPN: 697 FMI: 4 Auxiliary PWM Driver 1 – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the analog torque circuit.

PACCAR PX-8 CM2150 (2007-09) Fault Code: 2557 PID: SID 057 SPN: 697 FMI: 3 Auxiliary PWM Driver 1 – Voltage Above Normal or Shorted to High Source. High signal voltage detected at the analog torque circuit.

PACCAR PX-8 CM2150 (2007-09) Fault Code: 2556 PID: SID 070 SPN: 729 FMI: 4 Intake Air Heater 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at the intake air heater signal circuit.

Regresar al blog

Idioma

País/región