Detroit Diesel

NOTE: This fault indicates that the Motor Control Module (MCM) detects a short to ground (voltage less than 4.7) on either of the MCM pins, listed in the chart below. Inspect the harness and repair as necessary. Verify repairs. PROBABLE CAUSES:1. Disconnect these sensors one at a time. If code goes inactive, replace component: Crank case ventilator speed sensor, intake manifold pressure sensor, fuel rail pressure sensor, water pump speed sensor, hydrocarbon doser pressure in sensor, hydrocarbon doser pressure out sensor, oil pressure sensor, camshaft position sensor, fan speed sensor, EGR delta P sensor, intake throttle valve, LPPO fuel pressure...

NOTE: Please see the step by step troubleshooting procedures for this specific code. PROBABLE CAUSES:1. Accelerator pedal harness/connector.2. Accelerator pedal. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3509 FMI 4 (MCM) The 5V Sensor Supply Bank 1 Circuit Failed Low Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3509 FMI 3 (MCM) The 5V Sensor Supply Bank 1 Circuit Failed High Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3482 FMI 7 (MCM) Fuel Cutoff Valve Failed Self Test Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3482 FMI 5 (MCM) Fuel Cut-Off Valve Circuit Failed Open Detroit DD13 EPA07 (2007-09) Fault Code:...

NOTE: Please see the step by step troubleshooting procedures for this specific code. PROBABLE CAUSES:Short to power on one of the following from the main 120-pin ECM connector:1. Pin 82 -turbocharger speed sensor, fuel pressure sensor, fuel compensation pressure sensor, engine oil pressure.2. Pin 85 – turbocharger inlet pressure/temp sensor, DPF inlet pressure sensor, DPF outlet pressure sensor.3. Pin 104 – fuel line pressure sensor, fuel compensation pressure sensor.4. Pin 105 – engine oil pressure, turbocharger inlet pressure sensor, turbocharger temperature sensor. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3510 FMI 2 (CPC) This Fault Indicates that the Throttle Pedal...

PROBABLE CAUSES:1. Accelerator pedal harness/connector.2. Accelerator pedal. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3510 FMI 3 (CPC) High Voltage Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3510 FMI 2 (CPC) This Fault Indicates that the Throttle Pedal Supply is Receiving Erratic Data Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3509 FMI 4 (MCM) The 5V Sensor Supply Bank 1 Circuit Failed Low Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3509 FMI 3 (MCM) The 5V Sensor Supply Bank 1 Circuit Failed High Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3482 FMI 7 (MCM) Fuel Cutoff Valve Failed Self Test...

DESCRIPTION:Accelerator pedal sensor failed low. MONITORED PARAMETER:Pedal supply voltage. TYPICAL ENABLING CONDITIONS:Always on MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:Two seconds DASH LAMPS:CEL ENGINE REACTION:None VERIFICATION:Key cycle: Ignition on. NOTE: Disconnect one sensor at a time. PROBABLE CAUSES:When code goes inactive, that is the sensor that has failed:1. Fuel line pressure sensor.2. Fuel compensation pressure sensor.3. Engine oil pressure sensor.4. Inlet manifold pressure/temperature sensor.5. DPF inlet pressure sensor.6. DPF outlet pressure sensor.7. Intake throttle valve.8. Camshaft position sensor. NOTE: If none go inactive, disconnect the 31-pin connector on left side of the engine. If code goes inactive,...