Tu carrito
😊 Product added to cart successfully
Product removed to cart successfully
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 411 FMI 0 (MCM) Exhaust Gas Recirculation Differential Pressure is Too High at Low Speeds and Loads
DESCRIPTION:EGR differential pressure too high (Low Box).
MONITORED PARAMETER:EGR delta pressure sensor.
TYPICAL ENABLING CONDITIONS:1. Start with engine off.2. Idle speed less than 900 rpm.3. Coolant temperature greater than 65°C (149°F).4. DPF zone 0.
MONITOR SEQUENCE:None
EXECUTION FREQUENCY:Once per drive cycle.
TYPICAL DURATION:20
DASH LAMPS:1. MIL2. CEL
ENGINE REACTION:Derate 25%
VERIFICATION:Shut engine off if it is running, start engine and warm it up by driving the vehicle such than coolant temperature is greater than 65°C (149°F), then let vehicle idle for greater than five minutes at less than 900 rpm.
PROBABLE CAUSES:1. EGR delta p sensor failure.2. EGR delta p connector/harness.3. EGR delta p pressure ports blocked.4. EGR valve failure.5. Inspect the EGR crossover tube and mixer pipe for excessive buildup. If excessive, replaced the EGR cooler.6. Inspect EGR system for leaks/damage/issues.
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 247 FMI 14 (CPC) Aftertreatment Control Module Reported Ash Mileage is Lower than the Common Powertrain Controller Stored Value
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 247 FMI 9 (CPC) Typically MCM Engine Hours Data Not Received or Stopped Arriving
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 247 FMI 1 (CPC) MCM Engine Hours Data Lower than Expected
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 247 FMI 0 (CPC) MCM Engine Hours Data Higher than Expected
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 191 FMI 19 (CPC) Transmission Output Speed Shaft Signal is Erratic
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 191 FMI 13 (CPC) This Diagnostic is Typically the Transmission Output Sped Shaft Signal is Missing