Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 9 (ACM) Coolant Temperature Signal Not Available via Controller Area Network (CAN)

DESCRIPTION:This fault code sets when the coolant temperature signal is not received from the MCM.

MONITORED PARAMETER:Outlet Coolant Temperature.

TYPICAL ENABLING CONDITIONS:Always enabled

MONITOR SEQUENCE:None

EXECUTION FREQUENCY:Always enabled

TYPICAL DURATION:10 Seconds

DASH LAMPS:1. MIL2. CEL

ENGINE REACTION:None

VERIFICATION:Ignition on

NOTE: If any engine computer modules have been programmed recently, clear the codes if they are not active.

NOTE: Turn key off, disconnect batteries for 5 minutes. Reconnect. If codes still active, refer to code 625-9.

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 9 (MCM) Coolant Temperature Signal Not Available via Controller Area Network

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 4 (MCM) Engine Coolant Outlet Temperature Circuit Failed Low

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 3 (MCM) Engine Coolant Outlet Temperature Circuit Has Failed High

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 2 (MCM) Coolant Outlet Temperature Not Plausible

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 0 (MCM) Coolant Temperature High

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 0 (CPC) Coolant Temperature High

Idioma