Cumminz

Circuit DescripitonNormally, switches, accelerators, and other components are connected to the engine control module (ECM) directly through individual wires. Multiplexing allows those same components to be hard wired to an original equipment manufacturer (OEM) vehicle electronic control unit (VECU) or transmission electronic control unit (ECU) in the cab. Then component values and states from components such as sensors, accelerators, and switches can be transmitted from the OEM VECU to the Cummins® ECM over the SAE J1939 data link. Messages sent from OEM VECUs or transmission ECUs are received by the Cummins® ECM and used for controlling the engine. The Cummins®...

Circuit DescriptionNormally, switches, accelerators, and other components are connected to the engine control module (ECM) directly through individual wires. Multiplexing allows those same components to be hard wired to an original equipment manufacturer (OEM) vehicle electronic control unit (VECU) or transmission electronic control unit (ECU) in the cab. Then component values and states from components such as sensors, accelerators, and switches can be transmitted from the OEM VECU to the Cummins® ECM over the SAE J1939 data link. Messages sent from OEM VECUs or transmission ECUs are received by the Cummins® ECM and used for controlling the engine. The Cummins®...

Circuit DescriptionNormally, switches, accelerators, and other components are connected to the engine electronic control module (ECM) directly through individual wires. Multiplexing allows those same components to be hard wired to an OEM VECU or transmission electronic control unit in the cab. Then component values and states from components (such as sensors, accelerators, and switches) can be transmitted from the OEM VECU to the Cummins® engine ECM over the SAE J1939 data link. Messages sent from the OEM Vehicle Electronic Control Unit (VECU) or transmission electronic control unit are received by the Cummins® engine ECM and used for controlling the engine....

Circuit DescriptionNormally, switches, accelerators, and other components are connected to the engine control module (ECM) directly through individual wires. Multiplexing allows those same components to be hard wired to an original equipment manufacturer (OEM) vehicle electronic control unit (VECU) or transmission electronic control unit in the cab. Then component values and states from components (such as sensors, accelerators, and switches) can be transmitted from the OEM VECU to the Cummins® ECM over the Society of Automotive Engineers (SAE) J1939 data link. Messages sent from the OEM VECU or transmission electronic control unit are received by the Cummins® ECM and used...

Circuit DescriptionThe engine control module uses the engine intake throttle actuator position sensor to determine whether or not the actuator is meeting the commanded position. The engine control module supplies 5 Volts to the engine intake throttle actuator position signal circuit, and the engine throttle actuator position sensor outputs a voltage signal to the engine control module based on the actuator position. The engine control module converts this signal into a percentage value, 0 to 100, indicating actuator position. A fully open actuator is equivalent to 100 percent. Component LocationThe engine throttle actuator position sensor is internal to the engine...