Tu carrito
😊 Product added to cart successfully
Product removed to cart successfully
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4215 PID: SPN: 563 FMI: 31 Anti-Lock Braking (ABS) Active- Condition Exists
Circuit DescriptionCertain anti-lock braking (ABS) controllers communicate with the engine control module (ECM) through the SAE J1939 data link. Under certain driving conditions, the anti-lock braking (ABS) controller can send a cruise control inhibit message to the ECM and cruise control will temporarily be disabled.
Component LocationThe SAE J1939 data link wiring and the SAE J1939 devices vary by OEM options.
Conditions for Running the DiagnosticsThis diagnostic runs continuously when the engine is running.
Conditions for Setting the Fault CodesThe Engine Control Module (ECM) disabled cruise control due to an anti-wheel slip message from the anti-lock braking (ABS) controller.
Action Taken When the Fault Code is ActiveCruise control has temporarily been inhibited.Conditions for Clearing the Fault CodeTo validate the repair, perform a key cycle, and leave the key in the ON position for 1 minute.The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
Shop TalkThis is an information only fault code to indicate that cruise control was interrupted due to a message from the ABS controller. No troubleshooting is necessary.
Possible Cause:1) ECM calibration
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4213 PID: SPN: 3695 FMI: 2 Aftertreatment Regeneration Inhibit Switch- Data Erratic, Intermittent, or Incorrect
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4171 PID: SPN: 5745 FMI: 18 Aftertreatment 1 Diesel Exhaust Fluid Dosing Unit 1 Heater- Data valid But Below Normal Operating Range- Moderately Severe Level
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4169 PID: SPN: 5745 FMI: 4 Aftertreatment 1 Diesel Exhaust Fluid Dosing Unit 1 Heater Circuit- Voltage Below Normal or Shorted to Low Source
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4168 PID: SPN: 5745 FMI: 3 Aftertreatment 1 Diesel Exhaust Fluid Dosing Unit 1 Heater Circuit- Voltage Above Normal or Shorted to High Source
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4166 PID: SPN: 5743 FMI: 16 Aftertreatment Selective Catalytic Reduction Temperature Sensor Module- Data valid But Above Normal Operating Range- Moderately Severe Level
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4165 PID: SPN: 5743 FMI: 4 Aftertreatment Selective Catalytic Reduction Temperature Sensor Module- Voltage Below Normal or Shorted to Low Source