Ir directamente al contenido

Telegram : @Diezel365

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3141 PID: 102 SPN: 3667 FMI: 4 Engine Air Shutoff Circuit- Voltage Below Normal or Shorted to Low Source

Circuit DescriptionThe air shutoff valve is either an original equipment manufacturer (OEM) or Cummins? installed component that shuts off the flow of air into the intake of the engine in order to prevent an engine overspeed condition. When activated, the engine control module (ECM) supplies 12-VDC to the air shutoff solenoid. This solenoid then activates the valve, closing a plate over the intake.

Component LocationThe air shutoff valve is either an OEM or Cummins? installed component, and is usually located on the air intake connection.

Conditions for Running the DiagnosticsThis diagnostic runs continuously when the keyswitch is in the ON position or the engine is operating.

Conditions for Setting the Fault CodesThe ECM detects that the engine air shut off driver is shorted to ground.

Action Taken When the Fault Code is ActiveThe ECM illuminates the amber CHECK ENGINE light and/or the malfunction indicator lamp (MIL) immediately when the diagnostic runs and fails.Conditions for Clearing the Fault CodeTo validate the repair, start the engine and let it idle for 1 minute.The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.The ECM will turn off the amber CHECK ENGINE lamp after the diagnostic runs and passes.The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults.

Shop TalkPossible causes of this fault code include:

Short circuit to ground in the engine air shutoff circuitMalfunctioning ECM.Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.

Possible cause:1) Engine Air shutoff solenoid failure2) ECM failure

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3139 PID: SPN: 3667 FMI: 3 Engine Air Shutoff Circuit- Voltage Above Normal or Shorted to High Source
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3138 PID: SPN: 5019 FMI: 2 Engine Exhaust Gas Recirculation Outlet Pressure- Data Erratic, Intermittent, or Incorrect
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3137 PID: SPN: 5019 FMI: 4 Engine Exhaust Gas Recirculation Outlet Pressure Sensor Circuit- Voltage Below Normal or Shorted to Low Source
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3136 PID: SPN: 5019 FMI: 3 Engine Exhaust Gas Recirculation Outlet Pressure Sensor Circuit- Voltage Above Normal or Shorted to High Source
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3135 PID: SPN: 3610 FMI: 2 Aftertreatment Diesel Paticulate Filter Outlet Pressure- Data Erratic, Intermittent, or Incorrect
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 3134 PID: SPN: 3610 FMI: 4 Aftertreatment Diesel Particulate Filter Outlet Pressure Sensor Circuit- Voltage Below Normal or Shorted to Low Source