Volvo

Fault Condition: FMI 4 indicates there is a short circuit to ground in the starter relay control circuit. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Vehicle Electronic Control Unit (VECU) connector B. Check for continuity between the Vehicle Electronic Control Unit (VECU) connector B pin 28 and a good ground. If continuity exists to ground, locate andrepair the short circuit to ground. If there is NO continuity, verify the diagnostic code, the FMI and retest the system. If the FMI 4 is still active, replace the VECU and retest the system. Volvo All Engines (2004 Emissions)...

Fault Condition: FMI 5 indicates there is an open circuit in the starter relay control circuit. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Vehicle Electronic Control Unit (VECU) connector B. With Eaton A/T, disconnect the 20 Starter Enable Relay. Without Eaton A/T, disconnect the 36 Start Cntrl 1 Relay. With Eaton A/T, check for continuity between the Vehicle Electronic Control Unit (VECU) connector B pin 28 and 20 Starter Enable Relay pin 30. Without Eaton A/T, check for continuity between the Vehicle (VECU) connector B pin 28 and 36 Start Cntrl 1 Relay pin 85. If...

Fault Condition: FMI 7 indicates that starter engagement has been denied because the automated/automatic transmission is not in neutral. Possible repairs: Turn the ignition key OFF first. 1) If the FMI is 7 (mechanical system not responding), the starter engagement has been denied because the automated/automatic transmission is not in neutral. Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 10 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 14 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI...

Fault Condition: If the Engine Management System (EMS) Module detects a fault in the electrical circuit while attempting to operate the Fuel Injector Unit, the Electronic Malfunction Lamp (EML) will turn ON and code SID 4 will set. Possible repairs: Turn the ignition switch OFF first. 1) Disconnect the harness electrical connector from Fuel Injector Unit #4. Check for continuity between the pins 1 and 2 of the Fuel Injector Unit #4. If the resistance is NOT between 0.9-5.2 Ohms at 68°F (20°C) or 1.5-5.8 Ohms at 218°F (103°C), Fuel Injector #4 is faulty and must be replaced.2) Disconnect the...

Fault Condition: If the Engine Management System (EMS) Module detects a fault in the electrical circuit while attempting to operate the Fuel Injector Unit, the Electronic Malfunction Lamp (EML) will turn ON and code SID 4 will set. Possible repairs: Turn the ignition switch OFF first. 1) Disconnect the harness electrical connector from Fuel Injector Unit #4. Check for continuity between the pins 1 and 2 of the Fuel Injector Unit #4. If the resistance is NOT between 0.9-5.2 Ohms at 68°F (20°C) or 1.5-5.8 Ohms at 218°F (103°C), Fuel Injector #4 is faulty and must be replaced.2) Disconnect the...