Volvo

Fault Condition: When the Engine Management System (EMS) Module detects there is a short to voltage in the cooling fan control circuit. If there is an open circuit, FMI 5 will be set and the fan will operate continuously. If a customer complains that the fan clutch does not disengage and code SID 33 has not been logged in the EMS Module, the problem may be due to a mechanical failure in the chassis air system. Possible repairs: Warning: The fan can engage without warning. Hands, arms and personal items can easily be entangled in the belts or fan blades....

Fault Condition: FMI 0 indicates the starter estimated temperature has exceeded the manufacture’s limit. The starter can not be re-engaged until a cool down time down has occurred. Possible repairs: Turn the ignition key OFF first. 1) Check the Failure Mode Identifier (FMI) using a diagnostic computer. If the FMI is 0 (valid high), the starter estimated temperature has exceeded the manufacture’s limit. The starter can not be re-engaged until a cool down time down has past. Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI 3 Sensor Supply Voltage #2 Volvo All Engines (2004 Emissions) Fault Code: SID...

Fault Condition: FMI 10 indicates the command to the starter has been sent, but the engine is not turning. Possible repairs: Turn the ignition key OFF first. 1) If the FMI is 10 (abnormal rate of change), the command to the starter has been sent, but the engine is not turning. Check and diagnose the mechanical operation of the starting system. Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 14 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI 3 Sensor Supply...

Fault Condition: FMI 14 indicates the PTO is engaged and locks out the starter motor operation. Possible repairs: Turn the ignition key OFF first. 1) If the FMI is 14 (programming failure), the PTO is engaged and locks out the starter motor operation. Volvo All Engines (2004 Emissions) Fault Code: SID 39 FMI 0 Starter Output Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI 3 Sensor Supply Voltage #2 Volvo All Engines (2004 Emissions) Fault Code: SID 211 FMI 4 Sensor Supply Voltage #2 Volvo All Engines (2004 Emissions) Fault Code: SID 232 FMI 3 Sensor Supply Voltage...

Fault Condition: FMI 3 indicates there is a short circuit to voltage in the starter relay control circuit. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Vehicle Electronic Control Unit (VECU) connector B. Turn the ignition key ON. Measure the voltage between the VECU connector B pin 28 and a good ground. If voltage is present, the control line circuit isshorted to voltage. Locate the short to voltage, repair the circuit and retest the system. If there is NO voltage present, verify the diagnostic code, the FMI and retest the system. If the FMI 3 is still...