Volvo

Volvo All Engines (2017 Emissions) Fault Code: P020556 PID: EMS Cylinder 5 Injector “A” Circuit descriptionFuel Injector operation is controlled by the Engine Control Module (ECM). The ECM provides a common supply voltage to injectors 4,5,6 (Bank 2) and there are individual output transistor drivers inside the ECM to control each individual injector’s ground circuits. There are two solenoid circuits within the injector; a Needle Control Valve and a Spill Valve. Although they are separate circuits, the same fault code is used to identify a fault in the Needle Control Valve circuit and/or the Spill Valve circuit. Observable symptomsUneven operation...

Volvo All Engines (2017 Emissions) Fault Code: P020611 PID: EMS Cylinder 6 Injector “A” Conditions for diagnostic trouble code (DTC)Injector (INJ) activated Observable symptomsLow PowerLow PowerAbnormal noiseEngine is operating on only 5 cylinders Probable cause1) Connector2) Wiring harness3) Engine control module (ECM) Volvo All Engines (2017 Emissions) Fault Code: P020556 PID: EMS Cylinder 5 Injector “A” Volvo All Engines (2017 Emissions) Fault Code: P020513 PID: EMS Cylinder 5 Injector “A” Volvo All Engines (2017 Emissions) Fault Code: P020512 PID: EMS Cylinder 5 Injector “A” Volvo All Engines (2017 Emissions) Fault Code: P020511 PID: EMS Cylinder 5 Injector “A” Volvo All...

Volvo All Engines (2017 Emissions) Fault Code: P020612 PID: EMS Cylinder 6 Injector “A” Circuit descriptionFuel Injector operation is controlled by the Engine Control Module (ECM). The ECM provides a common supply voltage to injectors 4,5,6 (Bank 2) and there are individual output transistor drivers inside the ECM to control each individual injector’s ground circuits. There are two solenoid circuits within the injector; a Needle Control Valve and a Spill Valve. Although they are separate circuits, the same fault code is used to identify a fault in the Needle Control Valve circuit and/or the Spill Valve circuit. Conditions for diagnostic...

Volvo All Engines (2017 Emissions) Fault Code: P020613 PID: EMS Cylinder 6 Injector “A” Circuit descriptionFuel Injector operation is controlled by the Engine Control Module (ECM). The ECM provides a common supply voltage to injectors 4,5,6 (Bank 2) and there are individual output transistor drivers inside the ECM to control each individual injector’s ground circuits. There are two solenoid circuits within the injector; a Needle Control Valve and a Spill Valve. Although they are separate circuits, the same fault code is used to identify a fault in the Needle Control Valve circuit and/or the Spill Valve circuit. Conditions for diagnostic...

Volvo All Engines (2017 Emissions) Fault Code: P020A25 PID: EMS Cylinder 1 Injection timing Conditions for diagnostic trouble code (DTC):1) Unexpected electrical response Observable symptoms1) Power loss Probable cause1) Injector 12) Worn injector Detailed information1) The diagnostic trouble code (DTC) may be activated due to very low milage. If this happens the diagnostic trouble code (DTC) should change status to inactive after a while.2) Internal verification of the injector not possible Volvo All Engines (2017 Emissions) Fault Code: P020413 PID: EMS Cylinder 4 Injector “A” Volvo All Engines (2017 Emissions) Fault Code: P01B901 PID: EMS Engine Oil temperature Sensor “B”...