Your cart
😊 Product added to cart successfully
Product removed to cart successfully
PACCAR PX-8 CM2150 (2007-09) Fault Code: 386 PID: SID 212 SPN: 3509 FMI: 3 Sensor Supply 1 Circuit – Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply number 1 circuit.
Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM. If necessary, recalibrate the ECM.
Low voltage on the +5 volt supply wire can be caused by a short circuit to ground in a supply wire, a short circuit between a supply wire and a return wire, a failed sensor, or a failed ECM power supply.
Possible repairs:
1)Repair or replace the engine harness.
2)Replace the ECM.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 352 PID: SID 212 SPN: 3509 FMI: 4 Sensor Supply 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at sensor supply number 1 circuit.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 351 PID: SID 251 SPN: 627 FMI: 12 Injector Power Supply – Bad Intelligent Device or Component. The ECM measured injector boost voltage is low.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 343 PID: SID 254 SPN: 629 FMI: 12 Electronic Control Module Warning Internal Hardware Failure – Bad Intelligent Device or Component. ECM power supply errors have been detected.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 334 PID: 110 SPN: 100 FMI: 2 Engine Coolant Temperature – Data Erratic, Intermittent, or Incorrect. The engine coolant temperature reading is not changing with engine operating conditions.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 332 PID: SID 004 SPN: 654 FMI: 5 Injector Solenoid Driver Cylinder 4 Circuit – Current Below Normal or Open Circuit. High resistance or no current detected at cylinder 4 injector driver or return pin.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 331 PID: SID 002 SPN: 652 FMI: 5 Injector Solenoid Driver Cylinder 2 Circuit – Current Below Normal or Open Circuit. High resistance or no current detected at cylinder 2 injector supply or return pin.