Your cart
😊 Product added to cart successfully
Product removed to cart successfully
Eaton Gen 1 (AutoShift) Fault Code: 33 PID: PID 168 FMI: 4 Battery Voltage Supply
Overview:
This code indicates the system manager has detected that the battery power supply is low.
Detection:
The fault is detected immediately after power-up. This fault causes the service lamp to flash, but cannot be retrieved via key clicks (because turning the ignition key off at this point results in an immediate shutdown).
Fallback:
This fault causes an In Place fallback.
Required Tools:
1) Basic Hand Tools
2) Digital Volt/Ohm Meter
3) AutoSelect/AutoShift Troubleshooting Guide
Possible Causes:
1) Battery bus fuse/circuit breaker is open
2) Low batteries
3) Damaged tower or OEM harness
4) Damaged transmission harness
5) Malfunctioning power connect relay
6) Malfunctioning system manager ECU
Eaton Gen 1 (AutoShift) Fault Code: 31 PID: PID 62 FMI: 4 Engine Brake Relay Coil
Eaton Gen 1 (AutoShift) Fault Code: 31 PID: PID 62 FMI: 3 Engine Brake Relay Coil
Eaton Gen 1 (AutoShift) Fault Code: 17 PID: SID 237 FMI: 4 Start Enable Relay Coil
Eaton Gen 1 (AutoShift) Fault Code: 16 PID: SID 248 FMI: 2 Eaton Proprietary Link (EPL)
Eaton Gen 1 (AutoShift) Fault Code: 15 PID: SID 57 FMI: 2 Shift Lever Data Link
Eaton Gen 1 (AutoShift) Fault Code: 14 PID: SID 18 FMI: 12 Shift Lever