Detroit Diesel
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1845 FMI 9 (CPC) TCFG2 Message is Missing
Posted by Diezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If any battery voltage codes present, first those first. If code 625-9 active, fix that before proceeding as well. PROBABLE CAUSES:1. CPC recently programmed incorrectly.2. Another computer on the truck is the cause of the problems (ABS, Transmission, etc…) Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1761 FMI 31 (ACM) Diesel Exhaust Fluid (DEF) Tank Level 3 Condition – Tank Level Very Low Detroit DD13 EPA10 (2010-13) Fault Code: SPN 1761 FMI 18 (ACM) Diesel Exhaust Fluid (DEF) Tank Level 1 Condition – Empty Tank Detroit...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 188 FMI 31 (MCM) Idle Speed is Higher Than Targeted Idle Speed
Posted by Diezel Solutions on
DESCRIPTION:Idle speed out of range. MONITORED PARAMETER:Engine rpm TYPICAL ENABLING CONDITIONS:Engine rpm = idle. MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:10 seconds DASH LAMPS:MIL VERIFICATION:Engine Idle: One minute. PROBABLE CAUSES:1. If any camshaft or crankshaft codes, fix those first.2. If any throttle or idle validation switch codes, fix those next.3. Injector failure. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 175 FMI 15 (MCM) Oil Temperature High Pre-Warning Detroit DD13 EPA10 (2010-13) Fault Code: SPN 175 FMI 14 (MCM) Engine Oil Temperature Out of Range (Drifted Low/High) Detroit DD13 EPA10 (2010-13) Fault Code: SPN 175 FMI 4 (MCM)...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 190 FMI 0 (MCM) Engine Over Speed
Posted by Diezel Solutions on
DESCRIPTION:This fault code sets when the engine speed is above 2500 rpm. MONITORED PARAMETER:Engine speed TYPICAL ENABLING CONDITIONS:Engine speed greater than idle. MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:Two seconds DASH LAMPS:MIL ENGINE REACTION:Engine brakes are activated. VERIFICATION:Start and run the engine. POSSIBLE CAUSES:1. Vehicle was driven downhill in too low of a gear or without using the engine brakes.2. Crankshaft speed sensor fault.3. External combustible fluids drawn into the air intake. NOTE: This fault code can be induced by the driver while the vehicle is traveling downhill. There will be a message in the instrument cluster...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 190 FMI 9 (MCM) Engine Speed Signal Not Available via Controller Area Network
Posted by Diezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If the engine has had any computer programmed recently it can cause this code. Clear the codes and see if they come back. If they, follow 625-9 to fix. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 190 FMI 0 (MCM) Engine Over Speed Detroit DD13 EPA10 (2010-13) Fault Code: SPN 188 FMI 31 (MCM) Idle Speed is Higher Than Targeted Idle Speed Detroit DD13 EPA10 (2010-13) Fault Code: SPN 175 FMI 15 (MCM) Oil Temperature High Pre-Warning Detroit DD13 EPA10 (2010-13) Fault Code: SPN 175 FMI...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 191 FMI 13 (CPC) This Diagnostic is Typically the Transmission Output Sped Shaft Signal is Missing
Posted by Diezel Solutions on
DESCRIPTION:Transmission output shaft sped signal is missing. MONITORED PARAMETER:CAN communication TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:2 seconds DASH LAMPS:MIL VERIFICATION:Engine Idle: One minute. PROBABLE CAUSES:1. If battery fault codes present, fix this first.2. If any programming done recently on the engine, it may be incorrect.3. Check other computers on truck for failures (ABS, Transmission, cab controller, etc…). Detroit DD13 EPA10 (2010-13) Fault Code: SPN 191 FMI 9 (CPC) J1939 ETC1 Message is Missing Detroit DD13 EPA10 (2010-13) Fault Code: SPN 190 FMI 9 (MCM) Engine Speed Signal Not Available via Controller Area Network Detroit DD13...