Detroit Diesel
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3556 FMI 1 (MCM) Check for Regeneration Temperature Out of Range Low
Posted by Diezel Solutions on
NOTE: If codes 4077-0 or 3480-1 active, fix those first. PROBABLE CAUSES:1. Inspect entire exhaust system for leaks.2. Inspect all 3 temperature sensors on the DPF/DOC system.3. Inspect fuel line from doser block assy to the doser injection valve for kinks.4. Remove the doser injection valve and coolant block from turbo outlet and inspect for carbon buildup. If present, replace the doser injector valve.5. Clean the doser fuel lines.6. Perform stationary regen.7. Replace the HC doser block assy. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3512 FMI 3 (MCM) 3V Sensor Supply Bank 1 Circuit Failed High Detroit DD13 EPA07...
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 18 (MCM) Inlet Manifold Pressure Low
Posted by Diezel Solutions on
DESCRIPTION:This fault code sets when the intake manifold pressure is lower than expected while the engine is under a load. MONITORED PARAMETER:Intake manifold pressure. TYPICAL ENABLING CONDITIONS:Engine coolant temperature greater than 65°C (149°F). MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:15 seconds DASH LAMPS:1. MIL2. CEL ENGINE REACTION:None VERIFICATION:1. Engine coolant greater than 65°C (149°F).2. Drive at steady highway speed with loaded trailer.3. Engine rpm greater than 1130 for a minimum of five minutes. PROBABLE CAUSES:1. Failed inlet manifold pressure sensor.2. Inlet manifold pressure sensor connector/harness.3. Charge air cooler failure. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563...
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 20 (MCM) Ambient And Inlet Manifold Pressure Difference (Low Box)
Posted by Diezel Solutions on
DESCRIPTION:This fault sets when ambient and inlet manifold pressure difference is out of range low. MONITORED PARAMETER:Barometric pressure and intake manifold pressure. TYPICAL ENABLING CONDITIONS:Key cycle on. MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. DASH LAMPS:1. MIL2. CEL PROBABLE CAUSES:1. Failed inlet manifold pressure sensor.2. Inlet manifold pressure sensor connector/harness.3. Charge air cooler failure. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 18 (MCM) Inlet Manifold Pressure Low Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 4 (MCM) Intake Manifold Pressure Circuit Failed Low Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 3 (MCM) Intake Manifold...
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 21 (MCM) Ambient And Inlet Manifold Pressure Difference (High Box)
Posted by Diezel Solutions on
PROBABLE CAUSES:1. Failed inlet manifold pressure sensor.2. Inlet manifold pressure sensor connector/harness.3. Charge air cooler failure. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 20 (MCM) Ambient And Inlet Manifold Pressure Difference (Low Box) Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 18 (MCM) Inlet Manifold Pressure Low Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 4 (MCM) Intake Manifold Pressure Circuit Failed Low Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 3 (MCM) Intake Manifold Pressure Circuit Failed High Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3556 FMI 1 (MCM) Check for Regeneration Temperature Out...
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3563 FMI 3 (MCM) Intake Manifold Pressure Circuit Failed High
Posted by Diezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. PROBABLE CAUSES:1. Failed inlet manifold pressure sensor.2. Inlet manifold pressure sensor connector/harness.3. Charge air cooler failure. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3556 FMI 1 (MCM) Check for Regeneration Temperature Out of Range Low Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3512 FMI 3 (MCM) 3V Sensor Supply Bank 1 Circuit Failed High Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3511 FMI 3 (MCM) 3V Sensor Supply Bank 1 Circuit Failed High Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3510 FMI 8 (CPC) 2-Channel Accelerator Pedal...