Detroit DD16 GHG14 (2014-16) Fault Code: SPN 4077 FMI 3 (MCM) Doser Fuel Line Pressure Sensor Circuit Failed High

DESCRIPTION:
This fault code sets when the motor control module (MCM) detects that the hydrocarbon (HC) doser fuel line pressure (FLP) sensor circuit is failed high.

MONITORED PARAMETER:
Hydrocarbon (HC) doser fuel line pressure sensor.

TYPICAL ENABLING CONDITIONS:
Always enabled

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Always enabled

TYPICAL DURATION:
Two seconds

DASH LAMPS:
1. MIL
2. CEL

ENGINE REACTION:
None

VERIFICATION:
Engine Idle: One minute.

PROBABLE CAUSES:
1. If 4077-3 and 94-3 are present, repair the open between pin 104 of the ECM 120-pin connector and pin 4 (or pin 2 on DD15 engines) of the hydrocarbon doser fuel lines pressure sensors.
2. Failed fuel line pressure (FLP) sensor.
3. Wiring between the FLP sensor & the ECM.

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 4041 FMI 16 (CPC) Common Powertrain Controller Internal Failure

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 4041 FMI 9 (CPC) Common Powertrain Controller Internal Failure

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 4041 FMI 0 (CPC) Common Powertrain Controller Internal Failure

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3936 FMI 18 (ACM) Diesel Particulate Filter (DPF) Pressure – Out of Range Low

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3873 FMI 4 (CPC) Analog Output 02 – Failed Low, Indicated by a Short to Ground on Pin 6 of the Common Powertrain Controller #3 Connector

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3873 FMI 3 (CPC) Analog Output 02 – Failed High on Pin 6 Circuit of the Common Powertrain Controller (CPC) #3 Connector

Back to blog

Language

Currency