DESCRIPTION:This fault code sets when the motor control module (MCM) detects that the hydrocarbon (HC) doser fuel line pressure (FLP) sensor circuit is failed low.
MONITORED PARAMETER:Hydrocarbon (HC) doser fuel line pressure sensor.
TYPICAL ENABLING CONDITIONS:Always enabled
MONITOR SEQUENCE:None
EXECUTION FREQUENCY:Always enabled
TYPICAL DURATION:Two seconds
DASH LAMPS:1. MIL2. CEL
ENGINE REACTION:None
VERIFICATION:Engine Idle: One minute.
PROBABLE CAUSES:1. If 4077-3 and 94-3 are present, repair the open between pin 104 of the ECM 120-pin connector and pin 4 (or pin 2 on DD15 engines) of the hydrocarbon doser fuel lines pressure sensors.2. Failed fuel line pressure (FLP) sensor.3. Wiring between the FLP sensor & the ECM.
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 4077 FMI 3 (MCM) Doser Fuel Line Pressure Sensor Circuit Failed High
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 4041 FMI 16 (CPC) Common Powertrain Controller Internal Failure
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 4041 FMI 9 (CPC) Common Powertrain Controller Internal Failure
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 4041 FMI 0 (CPC) Common Powertrain Controller Internal Failure
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3936 FMI 18 (ACM) Diesel Particulate Filter (DPF) Pressure – Out of Range Low
Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3873 FMI 4 (CPC) Analog Output 02 – Failed Low, Indicated by a Short to Ground on Pin 6 of the Common Powertrain Controller #3 Connector