Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4193 FMI 4 (MCM) Engine Coolant Inlet Temperature Circuit Failed Low

DESCRIPTION:Engine coolant inlet temperature circuit failed low.

MONITORED PARAMETER:Engine coolant inlet temperature sensor.

TYPICAL ENABLING CONDITIONS:Always enabled

MONITOR SEQUENCE:None

EXECUTION FREQUENCY:Always enabled

TYPICAL DURATION:Two seconds

DASH LAMPS:1. MIL2. CEL

VERIFICATION:Engine Idle: One minute.

NOTE: If there are any cooling system faults or conditions, repair those first.

PROBABLE CAUSES:1. Inlet coolant temperature sensor.1. Inlet coolant temperature sensor connector/harness.

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4193 FMI 3 (MCM) Engine Coolant Inlet Temperature Circuit Failed High

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4193 FMI 2 (MCM) Coolant Inlet Temperature Not Plausible

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4100 FMI 13 (MCM, ACM) Motor Control Module or the Aftertreatment Control Module Software Not Compatible

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4077 FMI 14 (MCM) Hydrocarbon Doser Fuel Line Pressure Failed Self – Test

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4077 FMI 4 (MCM) Doser Fuel Line Pressure Sensor Circuit Failed Low

Detroit DD13 EPA10 (2010-13) Fault Code: SPN 4077 FMI 3 (MCM) Doser Fuel Line Pressure Sensor Circuit Failed High

Language