Detroit DD13 EPA07 (2007-09) Fault Code: SPN 110 FMI 2 (MCM) Coolant Outlet Temperature Not Plausible

DESCRIPTION:Coolant outlet temperature not plausible.

MONITORED PARAMETER:Coolant inlet and coolant outlet temperature sensors.

TYPICAL ENABLING CONDITIONS:1. Engine speed 500-2500 rpm.2. Coolant temperature is greater than 65C.3. Battery voltage is 11 vDC.4. Run engine less than 60s.

MONITOR SEQUENCE:None

EXECUTION FREQUENCY:Always enabled

TYPICAL DURATION:30

DASH LAMPS:MIL

VERIFICATION:Start engine, warm it up so that the coolant temperature is greater than 65C. Insure battery voltage is 11 vDC and engine has been running for at least 1 minute then bring engine to idle speed, being certain that it is greater than 500 RPM.

NOTE: If any other cooling system issues, repair those first.

PROBABLE CAUSES:1. Engine cooling system thermostat failure.2. Inlet and/or outlet coolant temperature sensor connector/harness.3. Inlet and/or outlet coolant temperature sensor.

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 110 FMI 0 (MCM) Coolant Temperature High

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 110 FMI 0 (CPC) Coolant Temperature High

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 108 FMI 13 (MCM, CPC, ACM) Ambient Air Pressure Signal Not Available via CAN

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 108 FMI 4 (MCM) Barometric Pressure (BP) Sensor Circuit Failed Low

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 108 FMI 3 (MCM) Barometric Pressure (BP) Sensor Circuit Failed High

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 103 FMI 4 (MCM) Turbo Speed Sensor Failed Low

Back to blog

Language

Currency