Cumminz

Language

28 May, 2025

0 comments

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 196 (3 wire sensor) PID: 111 SPN: 111 FMI: 4 Coolant Level Sensor 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at engine coolant level circuit.

Verify the ECM calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable fixes to the...

28 May, 2025

0 comments

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 1962 PID: SID 027 SPN: 641 FMI: 0 VGT Actuator Driver Over Temperature (Calculated) – Data Valid but Above Normal Operational Range – Least Severe Level. High Internal VGT actuator temperature has been detected.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

28 May, 2025

0 comments

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 1966 PID: 326 SPN: 3241

This fault code is logged when the ECM has detected a high temperature condition in the aftertreatment system and active...

28 May, 2025

0 comments

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 1968 PID: SPN: 3249

This fault code is logged when the ECM has detected a high temperature condition in the aftertreatment system and active...

28 May, 2025

0 comments

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 1969 PID: SPN: 3249

This fault code is logged when the ECM has detected a high temperature condition in the aftertreatment system and active...

28 May, 2025

0 comments

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 197 PID: 111 SPN: 111 FMI: 1 Coolant Level – Data Valid but Below Normal Operating Range – Moderately Severe Level. Low engine coolant level detected.

Verify the engine control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable...

Language

Currency

Cumminz