Cumminz

Language

09 June, 2025

0 comments

Cummins ISC CM2150 (2007-09) Fault Code: 1972 PID: SPN: 3245 FMI: 0 Exhaust Gas Temperature 3 – Data Valid but Above Normal Operational Range – Moderately Severe Level.

This fault code is logged when the ECM has detected a high temperature condition in the aftertreatment system and active...

09 June, 2025

0 comments

Cummins ISC CM2150 (2007-09) Fault Code: 1973 PID: SPN: 3245 FMI: 0 Exhaust Gas Temperature 3 – Data Valid but Above Normal Operational Range – Most Severe Level.

This fault code is logged when the ECM has detected a high temperature condition in the aftertreatment system and active...

09 June, 2025

0 comments

Cummins ISC CM2150 (2007-09) Fault Code: 1974 PID: 101 SPN: 101 FMI: 0 Crankcase Pressure – Data Valid but Above Normal Operational Range – Least Severe Level. The crankcase breather filter requires maintenance.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

09 June, 2025

0 comments

Cummins ISC CM2150 (2007-09) Fault Code: 1981 PID: SID 324 SPN: 3926 FMI: 0 Aftertreatment Particulate Filter Differential Pressure – Data Valid but Above Normal Operational Range – Least Severe Level.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable...

09 June, 2025

0 comments

Cummins ISC CM2150 (2007-09) Fault Code: 1993 PID: 3064 SPN: FMI: 11 Aftertreatment Particulate Trap Missing – Condition Exists. The aftertreatment diesel particulate filter in the exhaust system is not present.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

09 June, 2025

0 comments

Cummins ISC CM2150 (2007-09) Fault Code: 2182 PID: SID 79 SPN: 1072 FMI: 3 Engine Brake Actuator Driver 1 Circuit – Voltage Above Normal or Shorted to High Source. High voltage or open circuit detected at the engine brake solenoid number 1 signal circuit.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Language

Currency

Cumminz