Circuit DescriptionThe air shutoff valve position switch is located inside the air shutoff valve. During testing, the engine is accelerated and the air shutoff valve closes at a predetermined engine speed. When the air shutoff valve closes, the position switch closes. The ECM monitors the Air Shutoff Valve Position Signal circuit for a change indicating the switch closed.

Component LocationThe air shutoff valve position switch is located inside the air shutoff valve. The air shutoff valve is either an OEM or Cummins® installed component, and is usually located on the air intake connection.

Conditions for Running the DiagnosticsThis diagnostic only runs during an Air Shutoff Valve Test.

Conditions for Setting the Fault CodesThe ECM detects that the air shutoff valve position switch has not closed.

Action Taken When the Fault Code is ActiveThe ECM illuminates the red STOP ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.

Conditions for Clearing the Fault CodeTo clear the fault code and validate the repair, the air shutoff valve must be reset. The air shutoff valve test must be performed and the ECM must see the air shutoff valve position switch close.

Shop TalkPotential causes of this fault code include:

Malfunctioning air shutoff valve solenoid.Malfunctioning air shutoff valve.Malfunctioning air shutoff valve position switchBroken or disconnected air shutoff position switch SIGNAL wire.Broken or disconnected air shutoff position switch RETURN wire.

Possible Cause:1) OEM harness2) ECM calibration