Your cart
😊 Product added to cart successfully
Product removed to cart successfully
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4294 PID: SPN: 5097 FMI: 4 Engine Brake Active lamp- Voltage Below Normal or Shorted to Low Source
Circuit DescriptionThe brake lamp relay is an OEM optional component used to illuminate the vehicle’s brake lamps under conditions when the engine is braking.
Component LocationThe brake lamp relay is an OEM component. Refer to the OEM service manual for component location.
Conditions for Running the DiagnosticsThis diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.
Conditions for Setting the Fault CodesThe Engine Control Module (ECM) detected the brake lamp relay driver circuit was shorted to low source.
Action Taken When the Fault Code is ActiveThe ECM illuminates the amber CHECK ENGINE lamp immediately when the diagnostic runs and fails.Conditions for Clearing the Fault CodeTo validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.The Reset All Faults command in INSITE™ electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Shop TalkPossible causes of this fault code include:
Incorrect feature and parameter settingsA short circuit to ground in the OEM harness
Possible Cause:1) ECM calibration
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4293 PID: SPN: 5097 FMI: 3 Engine Brake Active lamp- Voltage Above Normal or Shorted to High Source
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4289 PID: SPN: 91 FMI: 8 Accelerator Pedal or Lever Position Sensor 1 Circuit Frequency- Abnormal Frequency or Pulse Width or Period
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4281 PID: SPN: 5848 FMI: 2 Aftertreatment 1 SCR Intermediate NH3- Data Erratic, Intermittent, or Incorrect
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4277 PID: SPN: 3364 FMI: 10 Aftertreatment Diesel Exhaust Fluid Quality- Abnormal Update Rate of Change
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4261 PID: SPN: 5743 FMI: 11 Aftertreatment Selective Catalytic Reduction Temperature Sensor Module- Root Cause Not Known
Cummins X15 CM2450 X124B (2018 & Newer) Fault Code: 4259 PID: SPN: 5742 FMI: 11 Aftertreatment Diesel Particulate Filter Temperature Sensor Module- Root Cause Not Known