Skip to content

Telegram : @Diezel365

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 2646 PID: 110 SPN: 110 FMI: 31 Engine Coolant Temperature- Condition Exists

Circuit DescriptionWhen the engine coolant temperature nears the engine protection limits, the exhaust gas recirculation (EGR) valve will be closed to reduce the coolant temperature. This fault code is used as an information fault code, only indicating that the EGR valve has closed.

Component LocationThe engine coolant temperature sensor is located on the thermostat housing.

Conditions for Running the DiagnosticsThis diagnostic runs continuously when engine speed is greater than 500 rpm.

Conditions for Setting the Fault CodesThe fault code is set active when the EGR valve is closed to reduce engine coolant temperature.

Action Taken When the Fault Code is ActiveThe ECM illuminates the amber CHECK ENGINE light immediately when the diagnostic runs and fails.Conditions for Clearing the Fault CodeTo validate the repair, perform a key cycle, and leave the key in the ON position for 1 minute.The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.The ECM will turn off the amber CHECK ENGINE lamp after the diagnostic runs and passes.The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults.

Shop TalkWhen the engine coolant temperature nears the engine protection limits, the EGR valve will be closed to reduce the coolant temperature. This fault code is used as an information fault code, only indicating that the EGR valve has closed. No malfunction has occurred to cause this fault code. Other engine protection fault codes will be active if the engine coolant temperature has exceeded the engine protection limits.

Possible Cause:1) ECM calibration

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 2639 (X) PID: SID 324 SPN: 3251 FMI: 15 Aftertreatment Diesel Particulate Filter Differential Pressure- Data Valid But Above Normal Operating Range- Least Severe Level
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 2639 (BCL) PID: SID 324 SPN: 3251 FMI: 15 Aftertreatment Diesel Particulate Filter Differential Pressure- Data Valid But Above Normal Operating Range- Least Severe Level
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 2638 (X) PID: SID 380 SPN: 5298 FMI: 17 Aftertreatment Diesel oxidation Catalyst Conversion Efficiency- Data Valid But Below Normal Operating range- Least Severe Level
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 2638 (BCL) PID: SID 380 SPN: 5298 FMI: 17 Aftertreatment Diesel oxidation Catalyst Conversion Efficiency- Data Valid But Below Normal Operating range- Least Severe Level
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 2637 (X) PID: SID 380 SPN: 5018 FMI: 11 Aftertreatment Diesel Oxidation Catalyst Face Plugged- Root Cause Not Known
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 2637 (BCL) PID: SID 380 SPN: 5018 FMI: 11 Aftertreatment Diesel Oxidation Catalyst Face Plugged- Root Cause Not Known