Your cart
😊 Product added to cart successfully
Product removed to cart successfully
Cummins ISM CM875 (2003-06) Fault Code: 241 PID: P084 SPN: 84 FMI: 2/2 Wheel-Based Vehicle Speed – Data Erratic, Intermittent, or Incorrect. The ECM lost the vehicle speed signal or is reading an erratic value.
There are multiple types of vehicle speed sensors. Various types include magnetic pickup, data link, digital, and tachograph. Refer to your OEM for the specific type installed on the vehicle.
This fault is set active when the ECM loses a vehicle speed signal when other engine conditions indicate the vehicle is moving. The fault can also become active if there is a series of clutch, service brake or throttle movements with no vehicle movement. The fault is set inactive when the ECM receives a vehicle speed signal greater than zero.
Since the vehicle speed sensor is an OEM installed component, this troubleshooting procedure will not catch all failures of the circuit due to components not under Cummins Inc. control. Sensor resistance values, data link speed sensors and tachographs are not fully covered under this procedure. For more information on those components, please refer to the OEM troubleshooting and repair manual.
Possible repair:
1)Replace the OEM harness.
Cummins ISM CM875 (2003-06) Fault Code: 234 PID: P190 SPN: 190 FMI: 0/0 Engine Crankshaft Speed/Position – Data Valid But Above Normal Operating Range – Most Severe Level. Engine speed signal indicates engine speed above engine protection limit.
Cummins ISM CM875 (2003-06) Fault Code: 227 PID: S232 SPN: 620 FMI: 3/3 Sensor Supply 2 Circuit – Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply number 2 circuit.
Cummins ISM CM875 (2003-06) Fault Code: 224 PID: S085 SPN: 1265 FMI: 3/3 Centinel? oil control valve circuit – shorted high. Open circuit or high signal voltage detected at Centinel? oil control valve circuit.
Cummins ISM CM875 (2003-06) Fault Code: 223 PID: S085 SPN: 1265 FMI: 4/4 Centinel? oil control valve circuit – shorted low. Low signal voltage detected at Centinel? oil control valve circuit.
Cummins ISM CM875 (2003-06) Fault Code: 222 PID: P108 SPN: 108 FMI: 4/4 Barometric Pressure Sensor Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at barometric pressure circuit.
Cummins ISM CM875 (2003-06) Fault Code: 221 PID: P108 SPN: 108 FMI: 3/3 Barometric Pressure Sensor Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage detected at barometric pressure circuit.