Je winkelwagen
😊 Product added to cart successfully
Product removed to cart successfully
PACCAR PX-8 CM2150 (2007-09) Fault Code: 111 PID: SID 254 SPN: 629 FMI: 12 Electronic Control Module Critical Internal Failure – Bad Intelligent Device or Component.
Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM. If necessary, recalibrate the ECM.
This fault code can only be caused by an internal ECM problem. Repairs are not possible for the ECM.
Possible repairs:
1)Replace the ECM.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 3616 PID: SPN: 2633 FMI: VGT Actuator Position – Special Instructions.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 2973 PID: 102 SPN: 102 FMI: 2 Intake Manifold 1 Pressure – Data Erratic, Intermittent, or Incorrect. The ECM has detected an intake manifold pressure signal that is too high or low for present engine operating conditions.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 2964 PID: 105 SPN: 105 FMI: 0 Intake Manifold 1 Temperature – Data Valid but Above Normal Operational Range – Least Severe Level. Intake manifold air temperature signal indicates intake manifold air temperature is above engine protection warning limit.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 2963 PID: 110 SPN: 110 FMI: 0 Engine Coolant Temperature – Data Valid But Above Normal Operational Range – Least Severe Level. Engine coolant temperature is above the engine coolant temperature engine protection warning limit.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 2962 PID: 412 SPN: 412 FMI: 0 Exhaust Gas Recirculation Temperature – Data Valid But Above Normal Operational Range – Moderately Severe Level. EGR temperature has exceeded the engine protection limit.
PACCAR PX-8 CM2150 (2007-09) Fault Code: 2961 PID: 412 SPN: 412 FMI: 0 Exhaust Gas Recirculation Temperature – Data Valid But Above Normal Operational Range – Least Severe Level. EGR temperature has exceeded the engine protection limit.