Detroit Diesel

NOTE: The common powertrain controller (CPC) digital outputs have the SPN as some motor control module (MCM) faults. The diagnostic service tool makes the distinction between the MCM and CPC when diagnosing a fault. NOTE: This diagnostic is typically MCM engine hours data lower than expected. This fault usually occurs after reprogramming the CPC or MCM. The internal clocks of the CPC or MCM do not match. After reprogramming either module, all fault codes must be cleared. NOTE: This error usually occurs after an improper ECM programming. ECM must be programmed correctly, most often the internal clocks don’t match. Detroit...

NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: This error usually occures after a re-programming. Detroit DD13 EPA07 (2007-09) Fault Code: SPN 247 FMI 9 (CPC) Typically MCM Engine Hours Data Not Received or Stopped Arriving Detroit DD13 EPA07 (2007-09) Fault Code: SPN 247 FMI 1 (CPC) MCM Engine Hours Data Lower than Expected Detroit DD13 EPA07 (2007-09) Fault Code: SPN 247 FMI 0 (CPC) MCM Engine Hours Data Higher than Expected Detroit DD13 EPA07 (2007-09) Fault Code: SPN 191 FMI 19 (CPC) Transmission Output Speed Shaft Signal is Erratic Detroit DD13 EPA07 (2007-09)...

NOTE: The common powertrain controller (CPC) digital outputs have the same SPN as some motor control module (MCM) faults. The diagnostic service tool makes the distinction between the MCM and CPC when diagnosing a fault. NOTE: This diagnostic is typically MCM engine hours data not received or stopped arriving. This fault usually occurs after reprogramming the CPC or MCM. The internal clocks of the CPC or MCM do not match. After reprogramming either module, all fault codes must be cleared. NOTE: You need to use diagnostic software to sync up the DPF ash accumulator with the ECM. This error usually...

DESCRIPTION:PWM pedal signal is missing. MONITORED PARAMETER:CAN communication TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:Two seconds DASH LAMPS:None ENGINE REACTION:None VERIFICATION:Ignition cycle Detroit DD13 EPA07 (2007-09) Fault Code: SPN 2623 FMI 4 (CPC) PWM Accelerator Pedal J1939 GAS2 Signal is Missing Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1845 FMI 9 (CPC) TCFG2 Message is Missing Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1716 FMI 9 (CPC) ERC1 Message is Missing Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1663 FMI 7 (MCM, CPC, ACM) Optimized Idle Safety Loop Faulted Detroit DD13 EPA07 (2007-09) Fault Code: SPN...

NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If any battery voltage codes present, first those first. If code 625-9 active, fix that before proceeding as well. PROBABLE CAUSES:1. CPC recently programmed incorrectly.2. Another computer on the truck is the cause of the problems (ABS, Transmission, etc…) Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1845 FMI 9 (CPC) TCFG2 Message is Missing Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1716 FMI 9 (CPC) ERC1 Message is Missing Detroit DD13 EPA07 (2007-09) Fault Code: SPN 1663 FMI 7 (MCM, CPC, ACM) Optimized Idle Safety Loop...