Cumminz

Taal

28 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 1938 PID: SPN: 3597 FMI: 1 ECU Power Output Supply Voltage 1 – Data Valid but Below Normal Operational Range – Moderately Severe Level. Low battery voltage detected by the VGT actuator.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

28 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 1942 PID: 101 SPN: 101 FMI: 2 Crankcase Pressure – Data Erratic, Intermittent, or Incorrect. The ECM has detected that the crankcase pressure signal is not changing with engine operating conditions.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable...

Meer lezen

28 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 1943 PID: SPN: 3555 FMI: 1 Ambient Air Density – Data Valid but Below Normal Operational Range – Least Severe Level. Engine torque has been reduced because the vehicle was operating at a high altitude condition.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

28 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 195 (2 wire sensor) PID: 111 SPN: 111 FMI: 3 Coolant Level Sensor 1 Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage detected at engine coolant level circuit.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

28 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 195 (3 wire sensor) 111 111 3 Coolant Level Sensor 1 Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage detected at engine coolant level circuit. PID: 111 SPN: 111

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

28 mei, 2025

0 reacties

Cummins ISB6.7 CM2150 (2007-09) Fault Code: 196 (2 wire sensor) PID: 111 SPN: 111 FMI: 4 Coolant Level Sensor 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the engine coolant level circuit.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable...

Meer lezen

Taal

Land/regio

Cumminz