Meteen naar de content

Telegram : @Diezel365

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 6422 PID: SPN: 1073 FMI: 4 Engine Brake Actuator Driver Output 2 Circuit- Voltage Below Normal or Shorted to Low Source

Circuit DescriptionThe engine control module (ECM) controls engine brakes on cylinders 4, 5, and 6 by sending a signal on the engine brake solenoid number 2 signal circuit. If an engine brake is installed, there will be a jumper harness from this connector to the engine brake pass-through connectors on the rocker lever housing.

Component LocationThe engine brake solenoids are located under the valve cover. The engine brake solenoids are controlled through the engine harness by the ECM.

Conditions for Running the DiagnosticsThis diagnostic runs when the keyswitch is in the ON position and when the pulse width modulated (PWM) device is getting energized or de-energized. In some cases, the diagnostics can also run at some fixed intervals.

Conditions for Setting the Fault CodesThe ECM detected the engine brake 2 PWM signal was not detected to be system voltage when the PWM signal was turned on.

Action Taken When the Fault Code is ActiveThe ECM logs the fault code immediately when the diagnostic runs and fails.The engine brake 2 circuit will be disabled.Conditions for Clearing the Fault CodeTo validate the repair, drive the vehicle and operate the engine brakes.This will allow the diagnostic to run. If the fault code does not become active again, the repair has been validated. The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the malfunction indicator lamp for on-board diagnostics applications.

Shop TalkPossible causes of this fault code include:

A short circuit to ground in the engine harnessA malfunctioning engine brake solenoid.

Possible Cause:1) N/A

Cummins ISX11.9 CM2250 (2010-12) Fault Code: 6421 PID: SID 254 SPN: 1073 FMI: 3 Engine Brake Actuator Driver Output 2 Circuit- Voltage Above Normal or Shorted to High Source
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 6419 PID: SPN: 1072 FMI: 4 Engine Brake Actuator Driver 1 Circuit- Voltage Below Normal or Shorted to Low Source
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 6418 PID: SPN: 1072 FMI: 3 Engine Brake Actuator Driver 1 Circuit- Voltage Above Normal or Shorted to High Source
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 6417 PID: SPN: 974 FMI: 19 SAE J1939 Mulitplexing Remote Accelerator Pedal or Lever Sensor System- Received Network Data In Error
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 6416 PID: SPN: 3703 FMI: 31 Aftertreatment Regeneration Inhibited Due To Inhibit Switch – Condition Exists
Cummins ISX11.9 CM2250 (2010-12) Fault Code: 6337 PID: SPN: 862 FMI: 4 Crankcase Breather Filter Heater Circuit- Voltage Below Normal or Shorted to Low Source