Je winkelwagen
😊 Product added to cart successfully
Product removed to cart successfully
Cummins ISX CM870 (2003-06) Fault Code: 343 PID: S254 SPN: 629 FMI: 12/12 Electronic Control Module Warning Internal Hardware Failure – Bad Intelligent Device or Component. ECM power supply errors have been detected.
This fault can also be caused by resistance in the ECM battery supply (+) or (-) circuits. Resistance in these circuits can cause the voltage level at the ECM input to drop low enough to set Fault Code 343 active.
Possible repair:
1)Replace the ECM.
Cummins ISX CM870 (2003-06) Fault Code: 341 PID: S253 SPN: 630 FMI: 2/2 Engine control module (ECM) data lost.
Cummins ISX CM870 (2003-06) Fault Code: 339 PID: S087 SPN: 1267 FMI: 4/4 Idle Shutdown Vehicle Accessories Relay Driver Circuit – Voltage Below Normal, or Shorted to Low Source. Low voltage detected at the idle shutdown vehicle accessory or ignition bus relay circuit when commanded ON.
Cummins ISX CM870 (2003-06) Fault Code: 338 PID: S087 SPN: 1267 FMI: 3/3 Idle Shutdown Vehicle Accessories Relay Driver Circuit – Voltage Above Normal, or Shorted to High Source. Open circuit or short to voltage source detected at the idle shutdown vehicle accessory/ignition bus relay circuit.
Cummins ISX CM870 (2003-06) Fault Code: 319 PID: P251 SPN: 251 FMI: 2/2 Real-Time Clock Power Interrupt – Data Erratic, Intermittent, or Incorrect. Real-time clock lost power.
Cummins ISX CM870 (2003-06) Fault Code: 295 PID: P108 SPN: 108 FMI: 2/2 Barometric Pressure – Data Erratic, Intermittent, or Incorrect. An error in the barometric pressure sensor signal was detected by the ECM.
Cummins ISX CM870 (2003-06) Fault Code: 288 PID: P029 SPN: 19 FMI: 19 SAE J1939 Multiplexing Remote Accelerator Pedal or Lever Position Sensor System – Received Network Data In Error. The OEM vehicle electronic control unit (VECU) detected a fault with the remote accelerator.