Je winkelwagen
😊 Product added to cart successfully
Product removed to cart successfully
Cummins ISM CM875 (2003-06) Fault Code: 692 PID: S151 SPN: 1172 FMI: 4/4 Turbocharger 1 Compressor Intake Temperature Circuit – Voltage Below Normal, or Shorted to Low Source. Low signal voltage
Beginning with ESN 14039654, the temperature sensor return circuit was separated from the pressure sensor return circuit. For ESNs prior to this and with engine wiring harness Part Number 3682854, refer to the Common Pressure/Temperature Sensor Return Circuit above. For this ESN and greater or for any other engine wiring harness part number, refer to the Separate Pressure/Temperature Sensor Return Circuit above.The turbocharger compressor inlet air temperature sensor shares return wires in the engine harness with other sensors. A shorted return can cause multiple fault codes to be active. Before troubleshooting Fault Code 692, check for multiple fault codes.
Possible causes:
1)Signal shorted to ground in the harness or ECM2)Signal shorted to return or ground in the sensor.
Possible repairs:
1)lace the turbocharger compressor intake air temperature sensor.2)Replace the ECM.3)Repair or replace the engine harness or sensor extension harness.
Cummins ISM CM875 (2003-06) Fault Code: 691 PID: S151 SPN: 1172 FMI: 3/3 Turbocharger Number 1 Compressor Inlet Temperature Sensor Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage detected at the turbocharger compressor inlet air temperature circuit.
Cummins ISM CM875 (2003-06) Fault Code: 689 PID: P190 SPN: 190 FMI: 2/2 Engine Crankshaft Speed/Position – Data Erratic, Intermittent, or Incorrect. The ECM has detected an error in the engine speed signal.
Cummins ISM CM875 (2003-06) Fault Code: 687 PID: P103 SPN: 103 FMI: 1/18 Turbocharger 1 Speed – Data Valid But Below Normal Operating Range – Moderately Severe Level. Low turbocharger speed detected by the engine control module (ECM).
Cummins ISM CM875 (2003-06) Fault Code: 649 PID: S153 SPN: 1378 FMI: 11/31 Change Lubricating Oil and Filter. Maintenance Monitor feature indicates the engine is due for a lubricating oil and filter change.
Cummins ISM CM875 (2003-06) Fault Code: 598 PID: P167 SPN: 167 FMI: 1/1 Electrical Charging System Voltage – Data Valid But Below Normal Operating Range – Most Severe Level. Very low battery voltage detected by the battery voltage monitor feature.
Cummins ISM CM875 (2003-06) Fault Code: 597 PID: P167 SPN: 167 FMI: 1/18 Electrical Charging System Voltage – Data Valid But Below Normal Operating Range – Moderately Severe Level. Low battery voltage detected by the battery voltage monitor feature.