Je winkelwagen
😊 Product added to cart successfully
Product removed to cart successfully
Cummins ISM CM875 (2003-06) Fault Code: 245 PID: S033 SPN: 647 FMI: 4/4 Fan Control Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the fan control circuit when commanded ON.
This fault code is logged when the ECM commands 12 or 24-VDC to the fan control solenoid, but the voltage on the fan control signal circuit is less than 12 or 24-VDC. The low voltage on the signal circuit usually indicates a short circuit to ground in the harness or solenoid.
If Fault Code 245 is still active after completing the following troubleshooting steps, consult the OEM service manual for procedures to check the fan control circuit for a short circuit to ground.
For intermittent power supply and datalink communication issues with Aftertreatment Components, it is highly recommended that the OEM Power Distribution Center fuses and relays be thoroughly checked for loose, missing or intermittent connections.
Possible repair:
1)Replace the fan control solenoid.2)Repair or replace the OEM harness.3)Replace the ECM.
Cummins ISM CM875 (2003-06) Fault Code: 242 PID: P084 SPN: 84 FMI: 10/10 Wheel-Based Vehicle Speed Sensor Circuit Tampering Has Been Detected – Abnormal Rate of Change. Signal indicates an intermittent connection or vehicle speed sensor (VSS) tampering.
Cummins ISM CM875 (2003-06) Fault Code: 241 PID: P084 SPN: 84 FMI: 2/2 Wheel-Based Vehicle Speed – Data Erratic, Intermittent, or Incorrect. The ECM lost the vehicle speed signal or is reading an erratic value.
Cummins ISM CM875 (2003-06) Fault Code: 234 PID: P190 SPN: 190 FMI: 0/0 Engine Crankshaft Speed/Position – Data Valid But Above Normal Operating Range – Most Severe Level. Engine speed signal indicates engine speed above engine protection limit.
Cummins ISM CM875 (2003-06) Fault Code: 227 PID: S232 SPN: 620 FMI: 3/3 Sensor Supply 2 Circuit – Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply number 2 circuit.
Cummins ISM CM875 (2003-06) Fault Code: 224 PID: S085 SPN: 1265 FMI: 3/3 Centinel? oil control valve circuit – shorted high. Open circuit or high signal voltage detected at Centinel? oil control valve circuit.
Cummins ISM CM875 (2003-06) Fault Code: 223 PID: S085 SPN: 1265 FMI: 4/4 Centinel? oil control valve circuit – shorted low. Low signal voltage detected at Centinel? oil control valve circuit.