Meteen naar de content

Telegram : @Diezel365

Cummins ISM CM875 (2003-06) Fault Code: 2321 PID: P190 SPN: 190 FMI: 2/2 Engine speed/position sensor number 1 – engine speed/position glitch detect (crankshaft sensor).

The CM870 controls are able to function almost normally on a single speed sensor. In the event that there is a signal glitch on the engine speed sensor, the system controls transfer to the camshaft position sensor. After awhile, the camshaft position sensor will transfer controls back to the engine speed sensor. When the controls transfer from one sensor to the next, a few actuator pulses may be skipped. This transition between sensors may be seen as a glitch, dropout, or miss. Fault Code 2321 serves as a tool to identify the source of those glitches in the event that a customer has a complaint regarding glitches, dropouts, or misses.

This fault becomes inactive at each key ON or if the ECM does not detect a loss of the engine speed sensor signal for at least 20 minutes.

Possible causes:

1)Loose, damaged, or corroded ECM or sensor connection2)Engine harness insulation damage3)Pushed back or bent ECM, sensor, or harness pins.

Actions to take if fault is intermittent:

1)Look for intermittent engine harness connections in the primary engine speed sensor circuit.

Possible repairs:

1)Repair or replace the engine harness.

Cummins ISM CM875 (2003-06) Fault Code: 2314 PID: S84 SPN: 1245 FMI: 11/31 Timing Actuator Number 2 CSircuit Error. Error detected on the rear timing actuator circuit.
Cummins ISM CM875 (2003-06) Fault Code: 2313 PID: S83 SPN: 1244 FMI: 11/31 Fueling Actuator Number 2 Circuit Error. Error detected on the rear fueling actuator circuit.
Cummins ISM CM875 (2003-06) Fault Code: 2312 PID: S20 SPN: 635 FMI: 11/31 Timing Actuator Number 1 Circuit Error. Error detected on the front timing actuator circuit.
Cummins ISM CM875 (2003-06) Fault Code: 2311 PID: S18 SPN: 633 FMI: 11/31 Fueling Actuator Number 1 Circuit Error. Error detected on the front fueling actuator circuit.
Cummins ISM CM875 (2003-06) Fault Code: 2278 PID: S27 SPN: 641 FMI: 4/4 Turbocharger Control Valve Circuit – shorted low. Low voltage detected at turbocharger control valve circuit.
Cummins ISM CM875 (2003-06) Fault Code: 2277 PID: S27 SPN: 641 FMI: 3/3 Variable Geometry Turbocharger Actuator Driver Circuit – Voltage Above Normal or Shorted to High Source. Open circuit or high voltage detected at turbocharger control valve circuit.