1)When the ECM is setup properly to receive information from an immobilizer anti-theft device, but the immobilizer anti-theft device may not actually be transmitting the message for that component. This can be caused when a multiplexed component is enabled in the Cummins ECM, but the immobilizer anti-theft device source address of the VECU transmitting the component message is incorrect in the Cummins ECM, or the immobilizer anti-theft device is not setup to transmit the multiplexed component message. 2)This fault can be caused by a bad J1939 datalink connection between the immobilizer anti-theft device and Cummins ECM , a bad connection between the component and the immobilizer anti-theft device, bad immobilizer anti-theft device or bad Cummins ECM. It may be necessary to contact the OEM for proper multiplexing configuration.
On-Board Diagnostics (OBD) Information:
1)The ECM illuminates the appropriate amber or red fault lamp when the diagnostic runs and fails. 2)The ECM turns off the appropriate fault lamp when the diagnostic runs and passes.