Volvo

Fault Condition: The Ambient Pressure Sensor is shorted to another circuit. If the code is active, attempt to clear the code from memory and check if the code resets. If PID 108 resets, replace the Engine Management System (EMS) Module and retest the system. Volvo All Engines (2004 Emissions) Fault Code: PID 108 FMI 2 Ambient Pressure Sensor Volvo All Engines (2004 Emissions) Fault Code: PID 108 FMI 4 Ambient Pressure Sensor Volvo All Engines (2004 Emissions) Fault Code: PID 158 FMI 4 Battery Voltage Volvo All Engines (2004 Emissions) Fault Code: PID 158 FMI 3 Battery Voltage Volvo All...

Fault Condition: The Ambient Pressure Sensor is shorted to another circuit. If the code is active, attempt to clear the code from memory and check if the code resets. If PID 108 resets, replace the Engine Management System (EMS) Module and retest the system. Volvo All Engines (2004 Emissions) Fault Code: PID 158 FMI 4 Battery Voltage Volvo All Engines (2004 Emissions) Fault Code: PID 158 FMI 3 Battery Voltage Volvo All Engines (2004 Emissions) Fault Code: PID 105 FMI 5 Boost Air Pressure / Temperature Sensor Volvo All Engines (2004 Emissions) Fault Code: PID 105 FMI 4 Boost Air...

Fault Condition: The Electronic Malfunction Lamp (EML) will turn on and Parameter Identification Code (PID) code P110 will set with Failure Mode Identifier (FMI) code 4 if the EMS Module senses that the ECT Sensor signal voltage is less than .17 volts. FMI code 5 will set if the ECT Sensor signal voltage is greater than 4.92 volts. If the EMS Module senses that the ECT Sensor signal is critically above range (219°F [104°C]), FMI code 0 will be set. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Engine Coolant Temperature (ECT) Sensor connector. Check for continuity...

Fault Condition: The Electronic Malfunction Lamp (EML) will turn on and Parameter Identification Code (PID) code P110 will set with Failure Mode Identifier (FMI) code 4 if the EMS Module senses that the ECT Sensor signal voltage is less than .17 volts. FMI code 5 will set if the ECT Sensor signal voltage is greater than 4.92 volts. If the EMS Module senses that the ECT Sensor signal is critically above range (219°F [104°C]), FMI code 0 will be set. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Engine Coolant Temperature (ECT) Sensor connector. Check for continuity...

Fault Condition: The Electronic Malfunction Lamp (EML) will turn on and Parameter Identification Code (PID) code P110 will set with Failure Mode Identifier (FMI) code 4 if the EMS Module senses that the ECT Sensor signal voltage is less than .17 volts. FMI code 5 will set if the ECT Sensor signal voltage is greater than 4.92 volts. If the EMS Module senses that the ECT Sensor signal is critically above range (219°F [104°C]), FMI code 0 will be set. Possible repairs: Turn the ignition key OFF first. 1) Disconnect the Engine Coolant Temperature (ECT) Sensor connector. Check for continuity...