Detroit Diesel
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 615 FMI 5 (MCM) Axial Power Turbine Air Seal Pressure Regulator Valve Circuit Failed Open
Posted by Diezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. PROBABLE CAUSES:1. APT air seal pressure regulator valve harness connector/wiring.2. APT air seal pressure regulator valve. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 615 FMI 4 (MCM) Axial Power Turbine Air Seal Pressure Regulator Valve Circuit Failed High Detroit DD13 EPA10 (2010-13) Fault Code: SPN 615 FMI 3 (MCM) Axial Power Turbine Air Seal Pressure Regulator Valve Circuit Failed High Detroit DD13 EPA10 (2010-13) Fault Code: SPN 609 FMI 14 (MCM) Motor Control Module Incorrect or Not Programmed Correctly Detroit DD13 EPA10 (2010-13) Fault Code: SPN 609...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 615 FMI 9 (MCM) J1939 DM1 Message from the Transmission is Missing
Posted by Diezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If codes for battery voltages are present, repair those first. NOTE: If code 625-9 present, repair that first. NOTE: Otherwise, the only reason that this code would appear would be because of improper programming in the ECM. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 615 FMI 5 (MCM) Axial Power Turbine Air Seal Pressure Regulator Valve Circuit Failed Open Detroit DD13 EPA10 (2010-13) Fault Code: SPN 615 FMI 4 (MCM) Axial Power Turbine Air Seal Pressure Regulator Valve Circuit Failed High Detroit DD13 EPA10 (2010-13) Fault...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 13 (MCM) Diagnostic Message Not Received this Ignition Cycle
Posted by Diezel Solutions on
NOTE: Please see the step by step troubleshooting procedures for this specific code. NOTE: If there are any battery related faults, repair those first. PROBABLE CAUSES:1. Wiring between the MCM 21-pin connector at pins 7, 11, 12, 14, or 15 and ground.2. Wiring between the MCM 21-pin connector at pins 5, 6, 8, or 9 and the battery.3. Corrosion/debris at the MEM 120-pin connector.4. Failed MCM. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 9 (MCM) Message Not Received or has Stopped Arriving Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 9 (CPC) Message Not Received or has...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 14 (CPC) MCM System ID/MCM_C01 Not Received or Stopped Arriving
Posted by Diezel Solutions on
DESCRIPTION:MCM message not received or has stopped arriving. MONITORED PARAMETER:CAN communication TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:Two seconds DASH LAMPS:1. MIL2. CEL ENGINE REACTION:None NOTE: If there are any battery related faults, repair those first. PROBABLE CAUSES:1. If any engine components have been programmed recently and are inactive, clear then and test drive to see if they return.2. Turn ignition off for 5 minutes (leave batteries connected) and turn back on to see if they went inactive.3. Measure resistance across MCM 12-pin connector at pins 13 and 19. If less than 5 ohms, replace the...
Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 17 (CPC) No ACM Communication – Pre Warning
Posted by Diezel Solutions on
NOTE: This fault indicates an interruption in ACM/MCM communication. NOTE: Follow code for 1231-9. Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 17 (MCM) No ACM Communication – Pre Warning Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 14 (CPC) MCM System ID/MCM_C01 Not Received or Stopped Arriving Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 13 (MCM) Diagnostic Message Not Received this Ignition Cycle Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 9 (MCM) Message Not Received or has Stopped Arriving Detroit DD13 EPA10 (2010-13) Fault Code: SPN 625 FMI 9 (CPC) Message Not Received...