Detroit Diesel

DESCRIPTION:This fault code sets when the engine speed is above 2500 rpm. MONITORED PARAMETER:Engine speed TYPICAL ENABLING CONDITIONS:Engine speed greater than idle. MONITOR SEQUENCE:None EXECUTION FREQUENCY:Continuous when enabling conditions met. TYPICAL DURATION:Two seconds DASH LAMPS:MIL ENGINE REACTION:Engine brakes are activated. VERIFICATION:Start and run the engine. POSSIBLE CAUSES:1. Vehicle was driven downhill in too low of a gear or without using the engine brakes.2. Crankshaft speed sensor fault.3. External combustible fluids drawn into the air intake. NOTE: This fault code can be induced by the driver while the vehicle is traveling downhill.; There will be a message in the instrument cluster...

DESCRIPTION:Transmission output shaft sped signal is missing. MONITORED PARAMETER:CAN communication TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:2 seconds DASH LAMPS:MIL VERIFICATION:Engine Idle: One minute. PROBABLE CAUSES:1. If battery fault codes present, fix this first.2. If any programming done recently on the engine, it may be incorrect.3. Check other computers on truck for failures (ABS, Transmission, cab controller, etc…). Detroit DD13 EPA07 (2007-09) Fault Code: SPN 191 FMI 9 (CPC) J1939 ETC1 Message is Missing Detroit DD13 EPA07 (2007-09) Fault Code: SPN 190 FMI 0 (MCM) Engine Over Speed Detroit DD13 EPA07 (2007-09) Fault Code: SPN 175...

DESCRIPTION:J1939 transmission output shaft speed signal is erratic. MONITORED PARAMETER:CAN Communication TYPICAL ENABLING CONDITIONS:Always enabled MONITOR SEQUENCE:None EXECUTION FREQUENCY:Always enabled TYPICAL DURATION:2 DASH LAMPS:MIL ENGINE REACTION:None VERIFICATION:Engine Idle: One minute. PROBABLE CAUSES:1. If battery fault codes present, fix this first.2. If any programming done recently on the engine, it may be incorrect.3. Check other computers on truck for failures (ABS, transmission, cab controller, etc…). Detroit DD13 EPA07 (2007-09) Fault Code: SPN 191 FMI 13 (CPC) This Diagnostic is Typically the Transmission Output Sped Shaft Signal is Missing Detroit DD13 EPA07 (2007-09) Fault Code: SPN 191 FMI 9 (CPC) J1939 ETC1...

NOTE: Fault will set during the transmission module reprogramming. If fault occurs while programming, clear code and release vehicle. PROBABLE CAUSES:1. If battery fault codes present, fix this first.2. If any programming done recently on the engine, it may be incorrect.3. Check other computers on truck for failures (ABS, Transmission, cab controller, etc…). Detroit DD13 EPA07 (2007-09) Fault Code: SPN 190 FMI 0 (MCM) Engine Over Speed Detroit DD13 EPA07 (2007-09) Fault Code: SPN 175 FMI 14 (MCM) Engine Oil Temperature Out of Range (Drifted Low/High) Detroit DD13 EPA07 (2007-09) Fault Code: SPN 175 FMI 4 (MCM) Engine Oil Temperature...

NOTE: The common powertrain controller (CPC) may have the same SPN as some motor control module (MCM) faults. The diagnostic service too makes the distinction between the MCM and CPC when diagnosing a fault. NOTE: This diagnostic is typically MCM engine hours data higher than expected. This fault usually occurs after reprogramming the CPC or MCM. The internal clocks of the CPC or MCM do not match. After reprogramming either module, all fault codes must be cleared. NOTE: This error usually occurs after an improper ECM programming. ECM must be programmed correctly, most often the internal clocks don’t match. Detroit...