Your cart
😊 Product added to cart successfully
Product removed to cart successfully
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 14 (MCM) Swapped Pins
NOTE: If the sensor is removed, be sure to check the sensor tip for metal debris and clutch material and clean it if necessary.
NOTE: If this SPN and FMI are active, verify that the wiring from crankshaft position (CKP) sensor pin 1 to pin 73 of the motor control module (MCM) 120-pin connector and that the wiring from CKP sensor pin 2 pin of the MCM 120 – pin connector is correct.
PROBABLE CAUSES:1. Crankshaft sensor connector/harness.2. Crankshaft sensor.3. Swapped pins on the connector.
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 11 (MCM) Crankshaft Position Sensor – Sensor Failure
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 10 (MCM) Crankshaft Position Sensor Signal Erratic
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 8 (MCM) Crankshaft Position Sensor Time Out
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 4 (MCM) Crankshaft Position Sensor Shorted to Ground
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 2 (MCM) No Match of Camshaft and Crankshaft Signals
Detroit DD13 EPA07 (2007-09) Fault Code: SPN 636 FMI 1 (MCM) Crankshaft Position Sensor Signal Voltage Too Low