Cumminz

Cummins ISB CM850 (2003-06) Fault Code: 271 (ISC – Auto) PID: SID 126 SPN: 1347 FMI: 4 High Fuel Pressure Solenoid Valve Circuit – Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the fuel pump actuator circuit. This fault becomes active when the ECM detects a short circuit in the electronic fuel control actuator circuit. Causes for this fault code are short circuit to ground or low resistance (fuel control actuator coil is shorted internally) in the circuit for the fuel pump actuator. When excessive current or a short circuit is detected, the ECM driver...

Cummins ISB CM850 (2003-06) Fault Code: 272 (Auto) PID: SID 126 SPN: 1347 FMI: 3 High Fuel Pressure Solenoid Valve Circuit – Voltage Above Normal or Shorted to High Source. Electronic fuel control actuator shorted high. This fault becomes active when the ECM detects an open in the electronic fuel control actuator circuit. Causes of this fault code are a short circuit to a positive voltage or an open circuit in the electronic fuel control actuator circuit. If there is high harness resistance, Fault Code 2311 could have high inactive counts. If the fault code is intermittent, look for causes...

Cummins ISB CM850 (2003-06) Fault Code: 272 (ISC – Auto) PID: SID 126 SPN: 1347 FMI: 3 High Fuel Pressure Solenoid Valve Circuit – Voltage Above Normal or Shorted to High Source. High signal voltage or open circuit detected at the fuel pump actuator circuit. This fault becomes active when the ECM detects an open in the fuel pump actuator circuit. Causes of this fault code are a short circuit to a positive voltage or an open circuit in the fuel pump actuator circuit. If there is high harness resistance or an intermittent open circuit, Fault Code 2311 could have...

Cummins ISB CM850 (2003-06) Fault Code: 275 PID: SID 126 SPN: 1347 FMI: 7 Fuel Pumping Element Number 1 (Front) – Mechanical System Not Responding Properly or Out of Adjustment. Fault Code 275 will most likely come active while operating at a steady state loaded condition. At this condition commanded fuel pressures are highest and the pump’s pressure balance is affected the most. If a high pressure seal has failed, pump head drain flow will be excessive. If a seal failure has progressed far enough, the engine may not start because of an inability to develop fuel rail pressure. If...

Cummins ISB CM850 (2003-06) Fault Code: 2771 PID: SPN: 3234 FMI: 9 Aftertreatment Outlet NOx Sensor – Abnormal Update Rate. No communications or valid data transfer rate detected on the J1939 datalink between the ECM and the aftertreatment outlet NOx sensor. On-Board Diagnostics (OBD) Information (Euro 4 Stage 1+ Certified Engines): 1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.2)An engine torque derate will be activated after 50 hours of engine operation with the fault code active.3)The ECM turns OFF the malfunction indicator lamp (MIL) after 1 ignition cycle that the diagnostic runs and does...